Get CTS-I Braindumps & CTS-I Real Exam Questions
AVIXA CTS-I Actual Questions and Braindumps
NEW QUESTION # 252
Because electrets are small, they lend themselves to a wide variety of _____ and quality levels.
- A. materials
- B. Applications
- C. condensers
- D. capacitors
Answer: B
NEW QUESTION # 253
The _____ of a surface varies inversely as the square of its distance from a light source.
- A. brightness
- B. Dispersion
- C. Illumination
- D. size
Answer: C
NEW QUESTION # 254
When a customer adds a newer model display to an existing digital AV system what will impact the system the most and should be reviewed?
Response:
- A. The color balance of the existing monitors should be redone
- B. The firmware version in the existing monitors should be updated
- C. The new display should have the exact same connections as the existing monitors
- D. The EDID table of the system should be reviewed and updated if necessary
Answer: C
NEW QUESTION # 255
If a digital signal is carried too far on a cable, the signal will become unreadable. This is called _____.
- A. The bit error rate
- B. The eye pattern effect
- C. The analog sunset
- D. The cliff effect
Answer: D
NEW QUESTION # 256
Which of the following documents should an AV integrator submit in the event that a manufacturer has discontinued a projector model?
- A. Letter of transmittal
- B. Progress report (PR)
- C. Request for change (RFC)
- D. Construction change directive (CCD)
Answer: C
NEW QUESTION # 257
An architectural drawing was created using the SI scale of 1:200. You measure a distance of 13 millimeters on the drawing. What is the actual distance in millimeters?
Response:
- A. 2,600 millimeters
- B. 5,200 millimeters
- C. 1,300 millimeters
- D. 260 millimeters
Answer: A
NEW QUESTION # 258
When working with electrical systems, what should you do if two codes have conflicting requirements?
- A. Follow the guidelines from the most lenient code
- B. Follow the guidelines from the most restrictive code
- C. Ignore both of the codes and do the installation in a way that makes sense to you
- D. Consult the NEC handbook and do only what it says
Answer: B
NEW QUESTION # 259
A technician installs a condenser microphone. It is not picking up audio. What is the MOST LIKLEY cause?
Response:
- A. Phantom power is turned off
- B. The cable run is too long
- C. Pins 2 and 3 are swapped at the XLR connector
- D. The microphone is defective
Answer: A
NEW QUESTION # 260
Estimating throw distance requires two values: ____ and ____.
- A. throw ratio; screen height
- B. screen width; throw ratio
- C. off-axis viewing location; throw ratio
- D. projector cart; tape measure
Answer: B
NEW QUESTION # 261
Heat dissipated by equipment in an AV rack is measured in:
Response:
- A. Watts
- B. Degrees
- C. BTU/H
- D. Coulombs
Answer: C
NEW QUESTION # 262
Which abbreviation on a drawing tells you that you will not need to install a specific display screen?
Response:
- A. OC
- B. NTS
- C. OD
- D. OFOI
Answer: D
NEW QUESTION # 263
Phantom power typically ranges from _____ VDC.
- A. 12 to 48
- B. 5 to 35
- C. 20 to 55
- D. 1 to 10
Answer: A
NEW QUESTION # 264
What does an elevation flag on a plan drawing indicate?
Response:
- A. Loudspeaker mounting details
- B. Detailed view of the elevator or lift
- C. Related elevation drawings
- D. An interior view of a wall structure
Answer: C
NEW QUESTION # 265
Which statement accurately describes what you should do when de-installing existing equipment?
Response:
- A. Smash the hardware so that data cannot be stolen
- B. Remove the connecting cables
- C. Dispose of equipment right away
- D. Call an electronic waste recycling contractor
Answer: B
NEW QUESTION # 266
What is the industry best practice when troubleshooting? (Choose all that apply.)
- A. Change the faulty device right away
- B. Change only one thing at a time
- C. Change the signal analyzer
- D. Change the signal generator
Answer: B
NEW QUESTION # 267
Which test verifies that a cable can transmit a signal from one end to another?
Response:
- A. Continuity test
- B. Impedance test
- C. Polarity test
- D. Signal sweep test
Answer: A
NEW QUESTION # 268
Signal processing circuitry and cables are subject to surrounding sources of _____.
- A. signal conductors
- B. unintended signals
- C. mechanical fields
- D. electrical noise
Answer: D
NEW QUESTION # 269
A _____ is a long flexible tape used to pull cable through conduit.
- A. Fish tape
- B. Tape measure
- C. Snout
- D. Mouse
Answer: A
NEW QUESTION # 270
The connector pictured below is known as:
Response:
- A. Direct connection termination
- B. Captive screw compression termination
- C. Ancillary dimpled solder connection
- D. Insulation displacement
Answer: B
NEW QUESTION # 271
How much pulling tension would a 24 AWG microphone cable with a 24 AWG signal cable shield drain wire be able to sustain?
- A. 5.4 kilograms (12 pounds)
- B. 10.9 kilograms (24 pounds)
- C. 8.2 kilograms (18 pounds)
- D. 7.2 kilograms (16 pounds)
Answer: A
NEW QUESTION # 272
Which of the following is an essential deliverable before sign-off?
Response:
- A. A punch list
- B. A clean site
- C. Redundant cables
- D. Referral solicitations
Answer: B
NEW QUESTION # 273
......
CTS-I Dumps To Pass AVIXA Exam in 24 Hours - TestSimulate: https://www.testsimulate.com/CTS-I-study-materials.html