Validate your 300-615 Exam Preparation with 300-615 Practice Test (Online & Offline)

Get all the Information About Cisco 300-615 Exam 2024 Practice Test Questions

NEW QUESTION # 59
Refer to the exhibit. The scheduler job fails to run. Which action resolves the issue?

• A. Configure the authentication credentials.
• B. Configure the RBAC authentication.
• C. Change the file name.
• D. Change the TFTP server address.

Answer: C

NEW QUESTION # 60
Refer to the exhibit.

Sw1 and Sw2 are two Cisco Nexus 9000 Series Switches that run Cisco NX-OS. They are VTEPs in the same vPC domain. Which statement describes what happens in this scenario?

• A. Sw2 did not send an IP PIM register to the rendezvous point for the multicast group of the VXLAN VNI.
• B. Sw1 and switch 2 perform the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs, depending on the hashing.
• C. Sw1 drops all traffic because there is no (S, G) OIF list to encapsulate VXLAN multicast packets and send them out to the underlay network through the uplink interfaces.
• D. Sw1 performs the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs.

Answer: D

NEW QUESTION # 61
Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.

Answer:

Explanation:

NEW QUESTION # 62
Refer to the exhibit. An engineer monitors a Cisco UCS server logs and discovers a blade discovery issue. Which procedure resolves the issue?

• A. 1. Verify that server platform power is failed
  2. Resolve the platform power issue.
  3. Reboot the server.
  4. Recommission the server.
• B. 1. Verify the server power module.
  2. Decommission the faulty module.
  3. Insert a new power module.
  4. Recommission the new module.
• C. 1. Verify that the power on self-test operation is failed.
  2. Verify that the server firmware is corrupted.
  3. Decommission the server firmware
  4. Recommission the server with new firmware.
• D. 1. Verify the FSM status on the server.
  2. Decommission the impacted server.
  3. Reset the slot where the server is located.
  4. Recommission the server.

Answer: D

NEW QUESTION # 63
Refer to the exhibit.

A PC belongs to VLAN 68 The user experiences a large amount of packet loss when communicating with hosts that are outside of VLAN 68. Which action resolves the problem?

• A. Replace HSRP with GLBP
• B. Enable the peer-gateway feature
• C. Configure ip arp synchronization on both switches.
• D. Remove the HSRP configuration

Answer: B

Explanation:
I assume that the PC is sending traffic with destination MAC of Nexus physical interfaces. If more snap shots about this question are available, please share.

NEW QUESTION # 64
An engineer is implementing a storage VDC, but fails. Which two prerequisites must be in place before a storage VDC is implemented? (Choose two.)

• A. M-Series module
• B. F-Series module
• C. FCoE license
• D. STORAGE-ENT license
• E. ESSENTIALS license

Answer: B,C

NEW QUESTION # 65
An engineer upgrades Cisco UCS firmware from release 3. 1(2) to release 3. 1(3) using Autolnstall. Both fabric interconnects go ofline during the software upgrade installation and issue multiple F SM retries in the DeployPollActivate stage. Which set of actions resolves the issue?

• A. Enable the management interface monitoring policy on the fabric interconnects. Initiate a configuration backup on both fabric interconnects.
  Commit the pending fabric interconnect reboot activity.
• B. Clear the startup version of the default infrastructure and server pack. Remove the service pack from the subordinate node.
  Upgrade with the Force attribute through Autolnstall.
• C. Acknowledge the error and reboot the primary fabric interconnect. Clear the default firmware version and upload a new one.
  Restart the upgrade process manually.
• D. Fix the rights to 666 with the debug plugin on the primary fabric interconnet Save the current configuration on the running fabric interconnect.
  Continue the upgrade on both fabric interconnects.

Answer: B

NEW QUESTION # 66
Refer to the exhibit.

A network engineer is implementing a Cisco UCS environment. The environment consists of eight servers configured with the same service profile template and Windows 2012 installed. The VFC interfaces of five of these servers are showing the error shown in the exhibit. Which action resolves the issue?

• A. Configure upstream zoning
• B. Modify the vHBAs name in the storage connectivity policy
• C. Decommission and recommission the servers
• D. Modify the boot order in the boot policy

Answer: C

NEW QUESTION # 67
Refer to the exhibit. The initiator that has FC ID 0x970102 fails to communicate with the target that has FC ID 0x970200. What action resolves the issue?

• A. Reset the port for FC ID 0x970102 and FC ID 0x970200 to log in to the fabric.
• B. Reactivate the zoneset.
• C. Reset the port for FC ID 0x970209 and FC ID 0x9700c2 to log in to the fabric.
• D. Reconfigure the initiator and the target to be in the same zones.

Answer: D

Explanation:
Members of different zones cannot access each other.
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_zones.pdf

NEW QUESTION # 68
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right.

Answer:

Explanation:

NEW QUESTION # 69
Refer to the exhibits. The server traffic fails to reach the storage array. Which action resolves the issue?

• A. Change the VLAN ID and VSAN ID at both ends.
• B. Remove and add new SFP on both ends.
• C. Change port speed to auto mode.
• D. Reboot and configure the M5K switches.

Answer: B

NEW QUESTION # 70
Refer to the exhibit.

Refer to the exhibit. One of the vPC VTEPs fails to route VXLAN traffic to vPC connected hosts. When the issue was being diagnosed, it was discovered that the packets that were expected to be forwarded to the MAC address on the SWITCH-VTEP-1 are instead forwarded to the MAC address on SWITCH-VTEP-2 and then dropped. Which action resolves the issue?

• A. Configure peer-gateway under the VPC domain on both peers
• B. Configure a different secondary IP address for one of the vPC peers
• C. Configure a distributed anycast gateway on both peers
• D. Configure ip arp synchronize under the VPC domain on both peers

Answer: A

Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/command/reference/vpc/n5k-vpc-cr/n5k-vpc_cmds_i.html#:~:text=a%20port%20profile.-,ip%20arp%20synchronize,no%20form%20of%20this%20command.

NEW QUESTION # 71
Refer to the exhibit. The servers experience intermittent connectivity issues in VLAN 10. Which action resolves the issue?

• A. Disable the preempt feature on one of the peer switches.
• B. Configure the same HSRP group on the peer switches.
• C. Change the virtual IP address on one of the peer switches.
• D. Enable HSRP hellos between the peer switches.

Answer: B

NEW QUESTION # 72
Drag and drop the actions from the left onto the faults that they resolve on the right. Not all options are used.

Answer:

Explanation:

NEW QUESTION # 73
An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.

Answer:

Explanation:

NEW QUESTION # 74
Refer to the exhibit.

When an engineer inserts 8-Gb FC SFP port 15 on a Cisco UCS Fabric Interconnect, the port fails. What is a possible cause of the issue?

• A. Port 15 is configured as an Ethernet port.
• B. Port 15 is missing a license.
• C. Port 15 is configured for 4-Gb FC.
• D. The polarity of the fiber cable is reversed.

Answer: C

NEW QUESTION # 75
Refer to the exhibit.

An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?

• A. Set the OSPF media type to point-to-point.
• B. Disable the check of the MTU value.
• C. Adjust the MTU on Router-B to 1604.
• D. Adjust the MTU on Router-A to 1600.

Answer: B

NEW QUESTION # 76
Refer to the exhibit.

HSRP adjacency fails to form between Nexus7K-1 and Nexus7K-2. Which action should be taken to solve the problem?

• A. Configure the correct subnet mask on Nexus7K-1.
• B. Configure HSRP version 2 on Nexus7K-2.
• C. Configure the same HSRP priority between the two switches.
• D. Configure preempt on one of the switches in the HSRP group.

Answer: B

NEW QUESTION # 77
Drag and Drop Question
An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.

Answer:

Explanation:

NEW QUESTION # 78
......

Check Real Cisco 300-615 Exam Question for Free (2024): https://www.testsimulate.com/300-615-study-materials.html