[Oct 25, 2021] Free NSE 7 Network Security Architect NSE7_SDW-6.4 Official Cert Guide PDF Download
Fortinet NSE7_SDW-6.4 Official Cert Guide PDF
NEW QUESTION 18
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. An absolute SD-WAN rule was defined and matched traffic.
- B. Traffic has matched none of the FortiGate policy routes.
- C. The FIB lookup resolved interface was the SD-WAN interface.
- D. Matched traffic failed RPF and was caught by the rule.
Answer: B,C
NEW QUESTION 19
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table.
- B. There are separate virtual interfaces for each dial-up client.
- C. FortiGate created a single IPsec virtual interface that is shared by all clients.
- D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
Answer: C,D
NEW QUESTION 20
What is the lnkmtd process responsible for?
- A. Flushing route tags addresses
- B. Logging interface quality information
- C. Monitoring links for any bandwidth saturation
- D. Processing performance SLA probes
Answer: C
NEW QUESTION 21
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- B. The 10 Mbps bandwidth is shared equally among the IP addresses.
- C. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- D. A single user uses the allocated bandwidth divided by total number of users.
Answer: C
Explanation:
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 22
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Reverse policy shaping mode
- B. Shared policy shaping mode
- C. Interface-based shaping mode
- D. Per-IP shaping mode
Answer: C
NEW QUESTION 23
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. FortiGate provides statistics and reading based on historical traffic logs.
- B. The debug output shows per-IP shaper values and real-time readings.
- C. This traffic shaper drops traffic that exceeds the set limits.
- D. Traffic being controlled by the traffic shaper is under 1 Kbps.
Answer: B,C
NEW QUESTION 24
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link health-check
Answer: A
NEW QUESTION 25
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link health-check
Answer: A
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 26
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set cost 15.
- C. Set source 100.64.1.1.
- D. Set load-balance-mode source-ip-ip-based.
Answer: C
NEW QUESTION 27
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- C. A single user uses the allocated bandwidth divided by total number of users.
- D. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
Answer: B
Explanation:
Explanation/Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 28
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two )
- A. All the existing sessions will continue to use port2 and new sessions will use port1
- B. All the existing sessions with no SNAT will start using port1 as the outgoing interface instead of port2
- C. All the existing sessions will be blocked from using port1 and port2
- D. All the existing sessions using SNAT will start using port1 as the outgoing interface instead of port2.
Answer: B,D
NEW QUESTION 29
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The application control profile must be enabled on the firewall policy.
- C. The URL category must be specified on the traffic shaping policy
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 30
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. Port2 might become alive when a single response is received from an SLA server
- C. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- D. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: D
NEW QUESTION 31
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- C. FEC transmits additional packets as redundant data to the remote device.
- D. FEC transmits the original payload in full to recover the error in transmission.
- E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
Answer: B,C
NEW QUESTION 32
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- C. Port2 might become alive when a single response is received from an SLA server
- D. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: B
NEW QUESTION 33
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. The guaranteed-10mbps option must be selected as the per-IP shaper option
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: B
NEW QUESTION 34
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- C. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- D. It acts as a policy compliance entity to review all managed FortiGate devices.
- E. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
Answer: C,D
NEW QUESTION 35
Which statement about using BGP routes in SD-WAN is true?
- A. Adding static routes must be enabled on all ADVPN interfaces.
- B. Learned routes can be used as dynamic destinations in SD-WAN rules.
- C. VPN topologies must be form using only BGP dynamic routing with SD-WAN.
- D. Dynamic routing protocols can be used only with non-encrypted traffic.
Answer: B
Explanation:
Explanation/Reference:
https://www.fortinetguru.com/2019/09/using-bgp-tags-with-sd-wan-rules-fortios-6-2/#:~:text=SD%2DWAN%
20rules%20can%20use,to%20the%20customer's%20data%20center.
NEW QUESTION 36
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. The FIB lookup resolved interface was the SD-WAN member interface
- B. Traffic has matched none of the FortiGate policy routes
- C. An absolute SD-WAN rule was defined and matched traffic
- D. Matched traffic failed RPF and was caught by the rule.
Answer: B,C
NEW QUESTION 37
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices
- B. It improves SD-WAN performance on the managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate
- E. It acts as a policy compliance entity to review all managed FortiGate devices
Answer: A,C
NEW QUESTION 38
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
- B. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- C. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
- D. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
Answer: B
NEW QUESTION 39
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link route-tag-list
- B. diagnose sys virtual-wan-link neighbor.
- C. diagnose sys virtual-wan-link member.
- D. diagnose sys virtual-wan-link service
Answer: B
NEW QUESTION 40
......
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
Free NSE7_SDW-6.4 Exam Dumps to Improve Exam Score: https://www.testsimulate.com/NSE7_SDW-6.4-study-materials.html