[Oct 03, 2022] NSE7_SDW-6.4 Exam Dumps - 100% Marks In NSE7_SDW-6.4 Exam!

Exam Dumps Use Real NSE 7 Network Security Architect Dumps With 54 Questions!

NEW QUESTION 22
Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

• A. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
• B. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
• C. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
• D. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.

Answer: C

 

NEW QUESTION 23
Refer to exhibits.


Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

• A. The guaranteed-10mbps option must be selected as the reverse shaper option.
• B. The guaranteed-10mbps option must be selected as the per-IP shaper option
• C. The reverse shaper option must be enabled and a traffic shaper must be selected
• D. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

Answer: A

 

NEW QUESTION 24
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

• A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
• B. Dead members require manual administrator access to bring them back alive
• C. SD-WAN interface becomes disabled and port1 becomes the WAN interface
• D. Port2 might become alive when a single response is received from an SLA server

Answer: A

 

NEW QUESTION 25
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

• A. diagnose sys virtual-wan-link route-tag-list
• B. diagnose sys virtual-wan-link neighbor.
• C. diagnose sys virtual-wan-link member.
• D. diagnose sys virtual-wan-link service

Answer: D

 

NEW QUESTION 26
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

• A. Specify outgoing interface routing cost.
• B. Configure SD-WAN rules interface preference.
• C. Select SD-WAN balancing strategy.
• D. Specify incoming interfaces in SD-WAN rules.

Answer: B

 

NEW QUESTION 27
Refer to exhibits.
Exhibit A.


Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?

• A. Both SD-WAN member interfaces have used separate SLA targets.
• B. Port1 became dead 1ecause no traffic was offload through the egress of port1.
• C. SD-WAN member interfaces are affected by the SLA state of the inactive interface
• D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Answer: A

 

NEW QUESTION 28
Refer to exhibits.


Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

• A. The guaranteed-10mbps option must be selected as the reverse shaper option.
• B. The reverse shaper option must be enabled and a traffic shaper must be selected
• C. The guaranteed-10mbps option must be selected as the per-IP shaper option
• D. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

Answer: B

 

NEW QUESTION 29
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

• A. Set source 100.64.1.1.
• B. Set cost 15.
• C. Set priority 10.
• D. Set load-balance-mode source-ip-ip-based.

Answer: B,C

 

NEW QUESTION 30
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

• A. Dead members require manual administrator access to bring them back alive
• B. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
• C. SD-WAN interface becomes disabled and port1 becomes the WAN interface
• D. Port2 might become alive when a single response is received from an SLA server

Answer: C

 

NEW QUESTION 31
Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

• A. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
• B. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
• C. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
• D. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.

Answer: C

 

NEW QUESTION 32
What is the lnkmtd process responsible for?

• A. Logging interface quality information
• B. Flushing route tags addresses
• C. Monitoring links for any bandwidth saturation
• D. Processing performance SLA probes

Answer: D

Explanation:
SD-WAN 6.4.5 Guide Page 105.

 

NEW QUESTION 33
Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

• A. Use unique Diffie Hellman groups on each VPN interface.
• B. Use different proposals are used between the interfaces.
• C. Specify a unique peer ID for each dial-up VPN interface.
• D. Configure the IKE mode to be aggressive mode.

Answer: A,B

 

NEW QUESTION 34
Which statement reflects how BGP tags work with SD-WAN rules?

• A. VPN topologies are formed using only BGP dynamic routing with SD-WAN
• B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
• C. BGP tags match the SD-WAN rule based on the order that these rules were installed.
• D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces

Answer: C

 

NEW QUESTION 35
What is the lnkmtd process responsible for?

• A. Logging interface quality information
• B. Flushing route tags addresses
• C. Monitoring links for any bandwidth saturation
• D. Processing performance SLA probes

Answer: C

 

NEW QUESTION 36
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

• A. FortiGate has terminated the session after a change on policy ID 1.
• B. Firewall policy ID 1 has source NAT disabled.
• C. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
• D. Changes have been made on firewall policy ID 1 on FortiGate.

Answer: D

 

NEW QUESTION 37
Which statement about using BGP routes in SD-WAN is true?

• A. Learned routes can be used as dynamic destinations in SD-WAN rules
• B. Dynamic routing protocols can be used only with non-encrypted traffic
• C. Adding static routes must be enabled on all ADVPN interfaces.
• D. VPN topologies must be form using only BGP dynamic routing with SD-WAN

Answer: D

 

NEW QUESTION 38
......

Pass Your NSE7_SDW-6.4 Exam Easily With 100% Exam Passing Guarantee: https://www.testsimulate.com/NSE7_SDW-6.4-study-materials.html