CompTIA PDI+ Beta Exam (PD1-001) Free Practice Test

Question 1

After gathering information in regards to a service issue, the next thing a technician should do is:

A. read the service documentation for possible causes.

B. establish a theory of possible causes.

C. validate the symptoms of the service issue.

D. check the parts life counters.

Correct Answer: C

Question 2

Which of the following settings should a technician change if communication response is unusually slow between a workstation and a printer?

A. SMB settings

B. Subnet mask settings

C. Half Duplex/full duplex settings

D. TCP/IP port settings

Correct Answer: C

Question 3

Which of the fol owing is a method of increasing the visual impression of green when printing on a CMYK printer?

A. Increase the level of CMYK equal y.

B. Increase the level of K in the print driver.

C. Increase the level of Y in the print driver.

D. Increase the level of M in the print driver.

Correct Answer: C

Question 4

APIPA is a form of:

A. wireless encryption.

B. dynamic IP addressing.

C. cable type.

D. network protocol.

Correct Answer: B

Question 5

A customer recently purchased a MFD and would like to setup scan using their SMTP server.
Which of the following type of scanning would be configured for the customer?

A. Scan-to-email

B. Scan-to-FTP

C. Scan-to-folder

D. TWAIN scanning

Correct Answer: A

Question 6

At what stage in the Laser/LED printing process is residual toner and charge removed?

A. Charging

B. Developing

C. Photoconductor preparation

D. Fusing

Correct Answer: C

Question 7

When using the PING command to communicate directly with a printer on the network, a response of Request Timed Out is generated. Which of the following is the MOST likely cause?

A. A paper jam has occurred.

B. A network cable is disconnected.

C. An account code is required.

D. The network print server is down.

Correct Answer: B

Question 8

In which of the following process steps are heat and pressure applied to the print media?

A. Charging

B. Developing

C. Writing

D. Fusing

Correct Answer: D

Question 9

When a technicians toner vacuum starts losing suction power, the MOST likely thing a technician should do is:

A. order a new toner vacuum.

B. replace the toner vacuum filter.

C. empty the toner vacuum filter into a trash can.

D. remove the toner filter and clean it.

Correct Answer: B

Question 10

Which of the following describes purging?

A. It is the process of eliminating waste ink produced during the printing process in an ink dispersion printing system.

B. It is the process of a vacuum preparing the print bed before the application of liquid color in a solid/block media printing system.

C. It is the process of cleaning nozzles and ejectors in an ink dispersion printing system.

D. It is the process of clearing excess toner off the electrostatic surface in a laser/LED printing system.

Correct Answer: C

Question 11

Which of the following runs a multi-functional device (MFD)?

A. BIOS

B. ROM

C. Firmware

D. RAM

Correct Answer: C

Question 12

Which of the following components can be found in the ADF unit on a multifunctional device?

A. Pressure roller

B. Separation pad

C. Heat lamp

D. Thermal Fuse

Correct Answer: B

Question 13

Which of the following are located in the laser unit?

A. Charge roller

B. Erase lamps

C. Toner

D. Lenses

E. Mirrors

Correct Answer: D,E

Welcome to TestSimulate

CompTIA PDI+ Beta (PD1-001) Free Practice Test