[Sep 21, 2021] 300-610 Ultimate Study Guide -  TestSimulate

Ultimate Guide to Prepare 300-610 Certification Exam for CCNP Data Center in 2021

NEW QUESTION 67
Refer to the exhibit.

Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?

• A. Initial
• B. Primary
• C. Secondary
• D. Updating

Answer: A

 

NEW QUESTION 68
Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?

• A. Each uplink that connects an IOM is configured as a discrete link.
• B. Cisco UCS Manager creates a single fabric port channel.
• C. The port channel is disabled until an administrator enables it manually.
• D. Cisco UCS Manager creates two separate fabric port channels.

Answer: D

 

NEW QUESTION 69
Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?

• A. Each uplink that connects an IOM is configured as a discrete link.
• B. Cisco UCS Manager creates a single fabric port channel.
• C. The port channel is disabled until an administrator enables it manually.
• D. Cisco UCS Manager creates two separate fabric port channels.

Answer: D

 

NEW QUESTION 70
What is a design consideration when implementing FSPF?

• A. Routes are based on the distance vector protocol.
• B. FSPF runs on a per-chassis basis.
• C. FSPF runs only on F Ports.
• D. Routes are based on the domain ID.

Answer: D

Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/ fabric/nxos/cli_fabric/fspf.html

 

NEW QUESTION 71
Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?

• A. Each uplink that connects an IOM is configured as a discrete link.
• B. Cisco UCS Manager creates a single fabric port channel.
• C. The port channel is disabled until an administrator enables it manually.
• D. Cisco UCS Manager creates two separate fabric port channels.

Answer: D

 

NEW QUESTION 72
Refer to the exhibit.

An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)

• A. SAN Pin Groups on the Cisco UCS Fabric Interconnects.
• B. NPV feature on the Cisco MDS Series.
• C. Smart Zoning feature on the Cisco UCS Fabric Interconnects
• D. NPIV feature on the Cisco MDS Series
• E. end-host mode feature on the Cisco UCS Fabric Interconnects

Answer: B,D

 

NEW QUESTION 73
A network architect designs a high-availability architecture for the Cisco UCS Fabric interconnects that installed in a data center. The architecture must support clustering and redundancy. Which architecture meets these requirements?

• A. dual connections from port L1 to L2 and one connection from port L2 to L1 with Ethernet cables dual
• B. dual connections from port L1 to 12 and one connection from port L2 to L1 with twinax cables
• C. dual connections from port L1 to L1and one connection from port L1 to L1 with twinax cables
• D. dual connections from port L1 to L1 and one connection from port L2 to L2 with Ethernet cables

Answer: D

Explanation:
Reference:

 

NEW QUESTION 74
A company has several data centers around the world that must be interconnected over Layer2. The service provider supports MPLS services to all the locations. The proposed solution must be vendor agnostic and scalable enough to support the rapid growth of the company. Which data center technology is recommended to achieve this goal?

• A. FabricPath
• B. OTV
• C. EoMPLS
• D. VXLANEVPN

Answer: D

 

NEW QUESTION 75
A company must introduce a scalable network automation tool to deploy, configure, and manage thousands of network device and service. The company servers already have been security-hardened and must not have any additional software installed on team. The security policy mandates the use of a secure communication protocol that support authentication and encryption for managing the servers. Which two automation tools must be used to meet these requirements? (Choose two.)

• A. Ansible
• B. Puppet
• C. Chef
• D. CFEngine
• E. Saltstack

Answer: B,E

 

NEW QUESTION 76
An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations.
Which two features must be used to prevent these situations from happening in the future? (Choose two.)

• A. delay restore
• B. ip arp synchronize
• C. auto-recovery
• D. system priority
• E. peer-gateway

Answer: A,C

 

NEW QUESTION 77
An engineer is experiencing performance issues on a Cisco UCS blade server. The B-Series blade server contains four CPUs, most of which are idle. The engineer notices that the CPU is suffering from too many requests sent by the NIC. Additionally, the number of queues appears to be insufficient and only a single CPU is processing the network traffic.
Which policy must be used to alleviate these issues?

• A. vNIC placement
• B. dynamic vNIC connection
• C. Ethernet adapter
• D. LAN connectivity

Answer: B

 

NEW QUESTION 78
A company has added a new FCoE storage array to increase the performance of datastore access for end users. This storage array is directly connected to the Cisco Nexus 5672UP switches using four 10G port-channel interfaces. After deployment, the end users fail to access the datastore compared to the older solution. A network engineer verified the port-channel interface and finds that the congestion occurs when PFC frames are generated at the FCoE ingress interface. Which action must be taken to resolve the congestion issue?

• A. Increase the queuing buffer in the port-channel interface connected to the storage array.
• B. Add an additional FCoE VLAN to the SAN network.
• C. Enable the FCoE class in QoS on Cisco Nexus 5672UP switches.
• D. Reserve bandwidth for FCoE VLAN on the port-channel interface connected with storage.

Answer: A

 

NEW QUESTION 79
An engineer must interconnect two geographically separated data centers. The service provide offers a Layer 2 metro Ethernet link. The strict security policy requires that the information that is shared between two sites must be sent encrypted. The application deployed between sites requires a line-rate throughput regardless of the packet size and speed. Which solution meets these requirements?

• A. MACsec
• B. L2TPv3
• C. L2TPv2
• D. IPsec

Answer: A

Explanation:
Reference:

 

NEW QUESTION 80
Refer to the exhibit.

The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?

• A. 2240 bytes
• B. 9000 bytes
• C. 2158 bytes
• D. 2000 bytes

Answer: D

Explanation:
Section: Storage Network Design

 

NEW QUESTION 81
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

Answer:

Explanation:

 

NEW QUESTION 82
......

CCNP Data Center Fundamentals-300-610 Exam-Practice-Dumps: https://www.testsimulate.com/300-610-study-materials.html