Prepare 201 Question Answers Free Update With 100% Exam Passing Guarantee [2022]

Dumps Real F5 201 Exam Questions [Updated 2022]

How to book the F5-201: TMOS Administration Exam

Register or log in on F5 Network website, or visit the Candidate Portal, or contact F5 Certification for more information.

 

NEW QUESTION 68
Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system. Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?

• A. The Connection Limit is set too low.
• B. The Connection Rate Limit is set too high
• C. The Rewrite Profile has NOT been configured.
• D. The server SSL Profile has NOT been reconfigured.

Answer: A

Explanation:
The topic explains that the connection reset behavior is caused by the vs configuration rather than the server resource problem. The answers B C are all configuration at the service forwarding level. If there is a problem with the configuration, it is all a problem rather than some users. Answer C's Connection Limit will cause a reset behavior when the connection reaches the threshold.

 

NEW QUESTION 69
A BIG-IP Administrator uses backend servers to host multiple services per server. There are multiple virtual servers and pools defined, referencing the same backend servers.
Which load balancing algorithm is most appropriate to have an equal number of connections on each backend server?

• A. Least Connections (node)
• B. Predictive (member)
• C. Least Connections (member)
• D. Predictive (node)

Answer: A

Explanation:
Explanation
The same set of servers provides multiple services, that is, using different ports to provide different services at the same time. The stem requirement is based on server connection balancing, not server + port, so it is node.

 

NEW QUESTION 70
Refer to the exhibit


The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

• A. Create a Floating Set IP Address
• B. Change Auto Last Hop to enabled
• C. Set Port Lockdown of Set IP to Allow All
• D. Assign a physical interface to the new VLAN

Answer: D

 

NEW QUESTION 71
When configuring a Virtual Server to use an iRule with an HTTP_REQUEST event, which lists required steps in a proper order to create all necessary objects.

• A. create required pools, create a custom HTTP profile, create the iRule, create the Virtual Server
• B. create profiles, create the iRule, create required pools, create the Virtual Server
• C. create a custom HTTP profile, create required pools, create the Virtual Server, create the iRule
• D. create the Virtual Server, create required pools, create the iRule, edit the Virtual Server

Answer: D

 

NEW QUESTION 72
Which Virtual Server type should be used to load balance HTTP traffic to a pool of servers?

• A. Standard
• B. Forwarding (Layer 2)
• C. Stateless
• D. Forwarding (IP)

Answer: A

 

NEW QUESTION 73
A virtual server is defined using a source address based persistence profile. The last five connections were A, B, C, A, C . Given the conditions shown in the graphic, if a client with IP address 205.12.45.52 opens a connection to the virtual server, which member will be used for the connection?

• A. 10.10.20.2:80
• B. 10.10.20.1:80
• C. 10.10.20.3:80
• D. 10.10.20.5:80
• E. 10.10.20.4:80

Answer: A

 

NEW QUESTION 74
Which statement
is true concerning the default
communication between a redundant pair of BIGElIP devices.

• A. Regardless of the configuration,
  some data is communicated between the systems at regular intervals.
• B. Connection mirroring data is shared through the serial faEl ilover cable unless network failover is enabled.
• C. Communication between the systems cannot be effected by
  port lockdown settings.
• D. Data for both connection and persistence mirroring are shared through the same TCP connection.

Answer: D

 

NEW QUESTION 75
A BIG-IP Administrator must configure the BIG-IP device to send system log messages to a remote syslog server In addition, the log messages need to be sent over TCP for guaranteed delivery. What should the BIG-IP Administrator configure?

• A. syslog-ng
• B. Request Logging Profile
• C. HSL Logging
• D. Remote Logging

Answer: D

 

NEW QUESTION 76
A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it. Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B.
What should the BIG-IP Administrator do to ensure the new VLAN is configured on each Cluster Member?

• A. Configure the new VLAN manually on Cluster Member B.
• B. Enable the Interface that is attached to the new VLAN on Cluster Member A.
• C. Configure a Default Route for the new VLAN on Cluster Member A.
• D. Reset the Device Trust of the BIG-IP Cluster on either Cluster Member.

Answer: A

 

NEW QUESTION 77
As a part of the Setup Utility, the administrator sets the host name for the BEl IGP.
What would be the result if the two systems in a redundant pair were set to the
same host name.

• A. Host names do not matter in redundant pair communication.
• B. In a redundant pair, the two systems will always have the same host name. The parameter is synchronized between the systems.
• C. When the administrator attempts to access the configuration utility using the host name, they will always connect to the active system.
• D. The first
  time
  the systems
  are synchronized
  the receiving
  system will be assigned the same selfElIP addresses as the source system.

Answer: D

 

NEW QUESTION 78
Which three properties can be assigned to nodes. (Choose three.)

• A. connection limits
• B. ratio values
• C. priority values
• D. health monitors
• E. loadElbalancing mode

Answer: A,B,D

 

NEW QUESTION 79
Which event is always triggered when the client sends data to a virtual server using TCP.

• A. VS_CONNECTED
• B. HTTP_REQUEST
• C. HTTP_DATA
• D. CLIENT_DATA

Answer: D

 

NEW QUESTION 80
Refer to the exhibit.

Which two pool members should be chosen for a new connection? (Choose two.)

• A. 172.16.15.1.80
• B. 172.10.15.2.80
• C. 172.16.15.4.80
• D. 172.16.15.9.80
• E. 172.16.15.7.80

Answer: C,E

 

NEW QUESTION 81
Refer to the exhibit
The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

• A. Create a Floating Set IP Address
• B. Change Auto Last Hop to enabled
• C. Set Port Lockdown of Set IP to Allow All
• D. Assign a physical interface to the new VLAN

Answer: D

 

NEW QUESTION 82
A user wants to use the iHealth Upgrade Advisor to determine any issues with upgrading TMOS from 13.0 to 13.1.
Where can the user generate the QKView to upload to iHealth?

• A. System > Archives
• B. System > Software Management
• C. System > Support
• D. System > Configuration

Answer: C

 

NEW QUESTION 83
A Virtual Server uses an iRule to send traffic to pool members depending on the URI. The BIG-IP Administrator needs to modify the pool member in the iRule.
Which event declaration does the BIG-IP Administrator need to change to accomplish this?

• A. CLIENT_ACCEPTED
• B. HTTP_RESPONSE
• C. SERVER_CONNECTED
• D. HTTP_REQUEST

Answer: D

Explanation:
According to the UR! distribution is the category of HTTP requests, need to trigger HTTP_REQUEST event.

 

NEW QUESTION 84
Refer to the exhibit.

Which Pool Members are receiving traffic?

• A. serv1
• B. serv1, serv3, serv4
• C. serv1, serv3
• D. Serv1, serv2,serv3, serv4

Answer: B

 

NEW QUESTION 85
Refer to the exhibit.

How are new connections load balanced?

• A. To the pool member with a low priority group value defined
• B. To the first two members listed with the same priority group
• C. To the pool member with a high priority group value defined
• D. To the pool member with the least number of connections

Answer: D

 

NEW QUESTION 86
......

201 Exam Dumps, 201 Practice Test Questions: https://www.testsimulate.com/201-study-materials.html