Avaya Ethernet Routing Switch Implementation Exam (6101-1) Free Practice Test

Question 1

Which SMLT resiliency feature uses the Soft Down option?

A. Simple Loop Prevention Protocol (SLPP)

B. extended Control Packet limit (ext-CP limit)

C. virtual Link Aggregation Control Protocol (VLACP)

D. discards untagged frames

Correct Answer: B

Question 2

A technician is troubleshooting some IP telephones that arc connected to an Ethernet
Routing Switch (ERS) 8300 8348TX-PWR I/O module. the IP telephones will not turn on the 48V LED on the module has been checked and it is steady amber.
What does this indicate?

A. 48V is not available

B. 48V is present

C. Module is booting

D. PoE is disabled

Correct Answer: C

Question 3

Consider four software upgrade events on an Ethernet Routing Switch (ERS) 2500 series
switch:
1.Upgrade the software image
2.The System Reboots
3.Backup the binary configuration to a TFTP server
4.Upgrade the boot/diagnostic code, if the new version is available
Which sequence of events will correctly upgrade the software?

A. 3.2.1.4

B. 1.4.2.3

C. 3.2.4. 1

D. 3.4.2.1

E. 1.2.4.3

Correct Answer: D

Question 4

Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

A. the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.

B. RSML T dynamically balances the CPU load across the switch cluster.

C. RSMLT edge is easier to configure and lightens the CPU load,

D. RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.

E. RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.

Correct Answer: C,D

Question 5

A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches.
Which statement about the correct uplink configuration is true?

A. Use unique MLT IDS for each stack of edge ERS 5500 switches

B. Disable auto negotiation and replace it with VLACP to identify single fiber fault failure

C. Distribute uplinks across different ERS 5500 switches in the stack.

D. Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.

Correct Answer: C

Question 6

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast
-
Sparse Mode (PIM-SM) Which licensing requirement applies?

A. the PIM-SM con only be licensed on ERS 5510 models

B. A Premier license is needed

C. the PIM-SM is already covered by the existing advanced feature license

D. the PIM-SM is included m the base license with release 6.2

Correct Answer: D

Question 7

Set of procedures will upgrade the boot monitor on an Ethernet Routing switch (ERS) 8600 with a single 8692SF module?

A. Copy the new Image to flash Boot the new image

B. Boot the new image

C. Modify the boot choice for run-time image

D. Copy the new image to flash Activate new image with SF module in service

E. Copy the new image to flash Modify the boot choice for rim-time image Boot the new image

Correct Answer: B

Welcome to TestSimulate

Avaya Ethernet Routing Switch Implementation (6101-1) Free Practice Test