Avaya Ethernet Routing Switch Implementation Sample Questions:

1. A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches must integrate two ERS 5600 units into existing stack of ERS 5500 switches.
What is the procedure for the integration of the new ERS 5600?

A) with power applied to the slack, change the existing ERS 5500 base unit to "Non Base Unit" in mixed stack operation Integrate the two new ERS 5600 to the stack with them set as "Base Unit" in mixed stack operation Reboot the stack.
B) With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. After the two ERS 5600 units have obtained their configuration from the ERS 5500 base unit, change the ERS 5500 to "non base unit" and set one ERS 5600 to "base unit". Reboot the switch stack.
C) Remove the AC from the stack, integrate the two ERS 5600 units into the existing 5600 set to "base unit" and one ERS 5600 set to "non base unit" set the existing ERS 5500 base unit to "non base unit" apply power to stack.
D) With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. Change the existing ERS 5500 base unit to "non base unit" and set the new 5600 to "base unit". Reboot the stack integrate the second ERS 5600 in mixed stack operational mode.

2. A technician has installed a license file on the Ethernet routing switch (ERS) 8800 and rebooted, but cannot configure the associated licensed features. it has been determined that license did not load properly at booyup time.
Which two must be verified?

A) The license file has .dat extension.
B) The switch is at the current release.
C) The license file is stored in the flash directory
D) The appropriate license level has been obtained.
E) The license filename contains valid characters.

3. With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features.
Which two statements ant true about the Advanced Routing License process and supported features for the ERS 8300? (Choose two.)

A) the Advanced Routing License supports SMLT, VRRP, OSPF, PIM-SM. and SLPP
B) the Advanced Routing License supports QoS, SMLT, VRRP and OSPF
C) To protect against security breaches, the ERS 8300 allows only a primary path for the license file
D) To protect against system flash failure, the ERS 8300 allows a primary, secondary, and tertiary path for the license file.

4.
The exhibit indicates the two show commands from an edge Ethernet Routing Switch (ERS) 5520-24T-PWR an untagged frame arrives on port 10.which is configured as an access port
To which VLAN will the packet be forwarded?

A) All untagged packets will be placed in VLAN 311
B) All untagged packets will he discarded.
C) All untagged packets will be placed in VLAN 31?
D) All untagged packets will be placed in the default VLAN (VLAN 1).

5. When configuring an Ethernet Routing Switch (ERS) 8600 for Split Multi link Trunking (SMLT). Protection against an edge switch in the factory default condition must be taken into consideration.
Which parameter WILL help prevent loops on the SMLT ports?

A) Spanning Tree Enable
B) Discard Looped Frames
C) LACP Enable
D) Discard Untagged Frames

Solutions: