Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) (300-135) Free Practice Test

Question 1

The implementations group has been using the test bed to do a 'proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing schemes, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolate the cause of this fault and answer the following question.
The fault condition is related to which technology?

A. NTP

B. Ipv4 Route Redistribution.

C. Ipv4 OSPF Routing

D. Ipv6 RIP Routing

E. Ipv4 and Ipv6 Interoperability

F. Ipv6 OSPF Routing

G. IP DHCP Server

H. Ipv4 layer 3 security.

I. Ipv4 EIGRP Routing.

Correct Answer: G

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 2

The implementations group has been using the test bed to do a 'proof-of-concept'. After several changes to the network addressing, routing schemes, a trouble ticket has been opened indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on DSW2(2026::102:1).
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?

A. ASW2

B. R2

C. DSW2

D. R4

E. R3

F. ASW1

G. DSW1

H. R1

Correct Answer: B

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 3

FCAPS is a network maintenance model defined by ISO. It stands for which of the following?

A. Configuration Management

B. Protocol Management

C. Action Management

D. Security Management

E. Fault Management

Correct Answer: A,D,E

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 4

What are two primary components of a GRE tunnel? (Choose two.)

A. payload packet

B. GRE header

C. Ethernet header

D. LLC header

E. IP header

Correct Answer: A,B

Question 5

Which of the following are shared distribution tree characteristics? (Choose all that apply.)

A. Place (*,G) entry in a router's multicast routing to table.

B. Uses a rendezvous point.

C. Place (S,G) entry in each router's multicast routing table.

D. Memory requirements are higher for shared distribution tree than for source distribution tree.

E. An optimal path is created between each source router and each last-hop router.

F. Creates a tree from a central RP to all last-hop routers.

Correct Answer: A,B

Question 6

The implementations group has been using the test bed to do a 'proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
What is the solution to the fault condition?

A. In Configuration mode, using the interface range Fastethernet 1/0/1 - 2, then switchport access mode vlan 10 command.

B. In Configuration mode, using the interface range Fastethernet 1/0/1 - 2, then switchport vlan 10 access command.

C. In Configuration mode, using the interface range Fastethernet 1/0/1 - 2, then switchport access vlan 10 command.

D. In Configuration mode, using the interface range Fastethernet 1/0/1 - 2, then switchport mode access vlan 10 command.

Correct Answer: C

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 7

Which of the following characteristics describe the Root Guard feature? (Choose all that apply.)

A. A Root Guard port receiving superior BPDU goes into a root-inconsistent state.

B. The port returns to a forwarding state if inferior BPDUs stop.

C. It should be applied to all switch ports.

D. While the port is in a root-inconsistent state no user data is sent across that port.

E. A Root Guard port receiving inferior BPDU goes into a root-inconsistent state.

F. The port must be put into forwarding state manually after root-inconsistent state has been corrected.

Correct Answer: A,D

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 8

Drag and drop the extended ping options from the left onto the troubleshooting functions they perform on the right.

Correct Answer:

Explanation
Data pattern = detects framing errors
Df-bit = Verify routing metrics
Hop count = prevents packet segmentation when set
ToS = Troubleshoots QoS issues
Validate Reply = verify that a packet was received

Question 9

Which of the following commands will remove all dynamic entries for a router's NAT table?

A. clear ip nat statistics

B. clear ip nat translations

C. clear ip nat translations all

D. clear nat translations

E. clear ip nat transactions *

F. clear ip nat translations*

Correct Answer: F

Welcome to TestSimulate

Cisco Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) (300-135) Free Practice Test