Specialist - Implementation Engineer, Campus Networking Exam (DES-5121) Free Practice Test

Question 1

A network administrator is setting up a Class 5 powered device in their network.
Which Dell EMC N-Serves switch model(s) will support this device?

A. N1100P and N2000P

B. N2000 and N3000P

C. N1500P

D. N3000P only

Correct Answer: B

Question 2

If a VRRP Master router is rebooted, what is the default behavior once it comes back online?

A. Original VRRP Master will take back control of the Master role

B. Original VRRP Backup will retain the Master role

C. VRRP Master role is determined by the router with the lowest MAC address

D. An election occurs to determine which router will have the Master role

Correct Answer: A

Question 3

Which switchport mode is recommended for ports on a Dell EMC N-Series switch with IP phones using voice VLAN?

A. Access

B. Hybrid

C. Active

D. General

Correct Answer: D

Question 4

What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?

A. N-Series switches can be configured to use ISDP or LLDP to communicate configuration information with Cisco devices

B. N-Series switches can be configured to use only CDP to communicate configuration information with Cisco devices

C. N-Series switches can be configured to use LLDP or CDP to communicate configuration information with Cisco devices

D. N-Series switches can be configured to use ISDP or CDP to communicate configuration information with Cisco devices

Correct Answer: A

Question 5

How many untagged VLANs are allowed on a switchport mode trunk interface?

A. 128

B. 0

C. 1

D. 4096

Correct Answer: C

Question 6

N4032F#show interfaces status

N4032F#show interfaces port-channel 1

Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
N4032F#
A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.
Based on the exhibit, why is only one link active?

A. Speed setting is different between ports

B. Minimum links value for Po1 is set to "1"

C. Hash algorithm is configured for active-passive

D. Te1/0/6 interface is administratively disabled

Correct Answer: A

Question 7

A network has two switches with the following IP addresses:
Switch1: 192.168.1.240
Switch2: 192.168.1.241
The administrator wants to add VRRP on an existing switch configuration using the virtual IP 192.168.1.240. What is a VRRP requirement for this configuration?

A. Virtual Router ID 240

B. Priority 255 on Switch1

C. Virtual Router ID 1

D. Priority 241 on Switch2

Correct Answer: B

Welcome to TestSimulate

EMC Specialist - Implementation Engineer, Campus Networking (DES-5121) Free Practice Test