NetApp Certified Support Engineer, ONTAP Specialist (NS0-592) Free Practice Test

Question 1

A customer has created an interface group (igroup) named a0a, a VLAN named a0a-2500, and a data LIF associated with the VLAN interface that has been assigned an IP of 10.254.10.100. The customer is able to ping 10.254.10.100 from a Windows client without any issues, but data traffic is not working.
In this scenario, what is the solution to the problem?

A. Disable flow control on the a0a interface.

B. Configure an appropriate service policy for the data LIF.

C. Correct the MTU mismatch between the broadcast domain configuration and the upstream network switches.

D. Allow data traffic by using LIF firewall policies.

Correct Answer: D

Question 2

A customer reports that one their SVMs has two default gateways. The customer wants to know whether this behavior is expected or if one of gateways should be deleted.
In this scenario, what do you tell the customer?

A. The configuration is acceptable if the customer configures different metrics on all defaults routes.

B. The configuration is acceptable only if both default gateways are in the same subnet.

C. This situation is a misconfiguration, and the customer should delete one of the default gateways because there can be only gateway for each SVM.

D. The configuration is acceptable. The customer can achieve load balancing between the default gateways by setting the same metric on all default routes.

Correct Answer: A

Question 3

Click the exhibit button.

A volume move operation has been initiated to move a volume named MirrScr from one aggregate to another.
The operation failed with the error that is shown in the exhibit.
In this scenario, which statement is correct?

A. Manually trigger the cutover process in order to restart the job.

B. There are too many snapshots on the source volume.

C. The volume move cannot be completed at this time because of high use in this node.

D. Cancel and restart the volume move operation.

Correct Answer: A

Question 4

Click the exhibit button.

Your customer reports that their FAS2554A system reports multi-path HA when running the sysconfig command. However, Config Advisor reports an error about incorrect cabling.
What are the two reasons for the messages? (Choose two.)

A. Disk shelves 10 and 20 are cabled incorrectly to each other.

B. The FAS2554 system is cabled incorrectly to shelf ID 20.

C. The DS2246 shelf is wrong; the shelf ID must be 11.

D. Shelves 10 and 20 have different IOM modules and must be in separate stacks.

Correct Answer: A,B

Question 5

A customer calls you about a performance issue that they experienced over the past few days. They want to know if data collection and root cause analysis (RCA) is possible for this issue. This issue appears to be a one time event.
Which tool would be used to satisfy the customer's request?

A. OneCollect

B. Performance Archive

C. perfstat

D. perfmon

Correct Answer: A

Question 6

Which statement is correct about the wafliron command?

A. The wafliron command is used to correct inconsistent WAFL metadata.

B. The wafliron command is used to correct inconsistent user data blocks.

C. The wafliron command is used to correct parity inconsistencies.

D. The wafliron command is used to correct WAFL i2p inconsistencies.

Correct Answer: A

Question 7

At a customer site, the storage failover giveback command fails when giving back the root aggregate.
What would be two reasons for this failure? (Choose two.)

A. The HA interconnect is not operational.

B. There are active NFS connections.

C. There are active SIS operations running.

D. There are failed disks.

Correct Answer: A,D

Welcome to TestSimulate

Network Appliance NetApp Certified Support Engineer, ONTAP Specialist (NS0-592) Free Practice Test