Installing Cisco TelePresence Video Immersive Systems (500-005) Free Practice Test

Question 1

When using the TX9000 AV expansion box, how many total video output signals can be obtained using a single video input?

A. two

B. four

C. three

D. one

E. six

F. five

Correct Answer: B

Question 2

The TX9000 left and right speakers connect to which component?

A. TS1 codec

B. center codec

C. AV expansion box

D. LCU

Correct Answer: A

Question 3

When a new TX9000 system is being installed, where does the TX9000 obtain its system image?

A. FTP

B. Domain Name Server

C. Cisco TelePresence Management Server

D. Cisco Unified Communications Manager

E. Cisco TelePresence Video Communication Server

Correct Answer: D

Question 4

Refer to the exhibit.

After the image name was specified for the TX9000 under the Cisco Unified Communications Manager Device Defaults screen, and the TX9000 was restarted, the TX9000 failed to upgrade to Cisco TelePresence System 1.9.1. Which of these caused this issue?

A. The TFTP service was not restarted.

B. The image name should be specified under the phone load that was filed in the device configuration.

C. The image name should be specified in the Cisco TelePresence System Administration configuration screen under Unified CM Settings.

D. The image name is incorrect; it is missing the .cop extension.

E. The image name is incorrect; it is missing the .cop.sgn extensions.

Correct Answer: A

Question 5

Which statement about the TX9000 codec is true?

A. It uses HTTPS for configuration.

B. It uses a cluster of six TX9000 codecs for redundancy.

C. The TX9000 allows for SIP and H.323 signaling.

D. It uses HTTP for configuration.

E. It uses the Cisco SIP standard.

Correct Answer: D

Welcome to TestSimulate

Cisco Installing Cisco TelePresence Video Immersive Systems (500-005) Free Practice Test