Implementing Cisco Service Provider VPN Services (300-515) Free Practice Test

Question 1

Refer to the exhibit. An engineer is implementing an MPLS P2MP TE solution.
Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?

A. transit

B. bud

C. source

D. headend

Correct Answer: B

Question 2

Refer to the exhibit. Which statement about this configuration is true?

A. 192.168.1.2 must be reachable by all routers participating in the mvpn-intranet MVRF.

B. Router 1 will accept multicast routes with a route-target of 12:1.

C. Router 1 has statically defined thresholds for data MDT.

D. The MVRF must be configured on each router on the customer and service provider networks.

Correct Answer: B

Question 3

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode?

A. RP/0/RP0/CPU0:PE(config-bgp-af)#

B. RP/0/RP0/CPU0:PE(config-vrf)#

C. RP/0/RP0/CPU0:PE(config-if)#

D. RP/0/RP0/CPU0:PE(config-bgp)#

Correct Answer: C

Question 4

What do routers on the network use to avoid routing loops when OSPF is running as the PE-CE routing protocol on a service provider network?

A. sham links to create a super backbone over the service provider network

B. the DN bit with type 3, 5, or 7 LSA

C. the AS-Override feature

D. the domain tag for type 2 LSA

Correct Answer: B

Question 5

A network engineer is implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers.
Which PE-to- CE routing protocol requires a separate routing process to be created for each VRF?

A. RIPv2

B. EIGRP

C. OSPF

D. BGP

Correct Answer: C

Question 6

Which optional information can be included with an IPv6 ping to support the troubleshooting process?

A. destination MAC address

B. source MAC address

C. IPv6 hostname

D. IPv4 IP address

Correct Answer: C

Question 7

Which is the primary function of a MPLS L3 VPN route target?

A. It imports and exports identified routes into selected VRFs.

B. It supports QoS by classifying traffic by file type when it applies MPLS EXP bits to each packet.

C. It uniquely identifies NLRIs that have the same numeric value.

D. It imports the external routes it identifies into VRFs that support Internet traffic

Correct Answer: A

Question 8

Refer to the exhibit. A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)

A. Type 2 routes contain inclusive source-specific multicast route information.

B. The operator adds in "host-routing" under the VRF EVPN.

C. Type 2 routes contain MAC/IP information.

D. Type 2 routes contain Ethernet Auto-Discovery information.

E. The operator adds in "host-routing" under the BVI651 interface.

Correct Answer: C,E

Question 9

In which configuration mode is a route distinguisher configured in a Cisco IOS XR router?

A. config-bgp-af

B. config-vrf

C. config-bgp-vrf

D. config-vrf-af

E. config-bgp

Correct Answer: C

Welcome to TestSimulate

Cisco Implementing Cisco Service Provider VPN Services (300-515) Free Practice Test