Implementation Engineer - MetroCluster Exam (NS0-014) Free Practice Test

Question 1

What is the primary role of the ATTO FibreBridge in a MetroCluster configuration?

A. Convert IP to Fibre Channel traffic

B. Connect disk shelves to controllers

C. Optimize network performance

D. Provide redundancy for network paths

Correct Answer: B

Question 2

What are two methods to verify that MetroCluster replication is functioning properly? (Choose two)

A. Verify data consistency using SnapMirror

B. Use the metrocluster check command

C. Perform a data validation using Config Advisor

D. Check IP route tables between sites

Correct Answer: A,B

Question 3

What are two key indicators of a successful switchover test in a MetroCluster environment?
(Select two)

A. Replication traffic switches to the secondary site

B. Replication traffic switches to the secondary site

C. The secondary site remains in read-only mode

D. All data services remain available during the test

Correct Answer: A,D

Question 4

What role does SyncMirror play in a MetroCluster configuration?

A. Data backup

B. Synchronous data mirroring between two sites

C. Asynchronous data replication

D. Load balancing

Correct Answer: B

Question 5

Which command is used to verify the health of a MetroCluster configuration in ONTAP?

A. metrocluster check connectivity

B. cluster status

C. metrocluster diagnostic show

D. metrocluster show

Correct Answer: D

Question 6

Which task is essential when expanding a MetroCluster system to support additional storage nodes?

A. Remove ATTO FibreBridges

B. Reinstall all controllers

C. Add new storage shelves and validate SyncMirror configuration

D. Disable all replication processes

Correct Answer: C

Question 7

What are two requirements when transitioning from an FC MetroCluster to an IP MetroCluster configuration? (Select two)

A. Upgrade to ONTAP 9

B. Install ATTO FibreBridges

C. Removal of all FC switches

D. Implementation of IP switches

Correct Answer: A,D

Question 8

What is a critical requirement for transitioning a MetroCluster environment from 7-Mode to Clustered ONTAP?

A. Using the 7-Mode Transition Tool

B. Replacing all storage hardware

C. Manually updating all ONTAP licenses

D. Reconfiguring IP switches

Correct Answer: A

Question 9

In a MetroCluster environment, which tool is used to validate the configuration before go-live?

A. Config Advisor

B. SnapMirror

C. System Manager

D. System Manager

Correct Answer: A

Welcome to TestSimulate

Network Appliance Implementation Engineer - MetroCluster (NS0-014) Free Practice Test