Hitachi Vantara Qualified Professional - VSP Midrange Family Installation (HQT-4180) Free Practice Test

Question 1

Which program is used to perform the "New Installation" procedure on a VSP F700 system?

A. SVP Web console

B. raidcom CLI

C. MPC connected to the maintenance LAN port

D. Hitachi Ops Center Administrator

Correct Answer: C

Question 2

What are two supported SAS back-end transfer speeds on the VSP Midrange systems? (Choose two.)

A. 12 Gb/s

B. 4 Gb/s

C. 8 Gb/s

D. 6 Gb/s

Correct Answer: A,D

Question 3

Which two statements are correct when adding cache to a VSP One B24? (Choose two.)

A. Cache Modules must be installed on the CM board

B. CMG0 and CMG1 must use the same DIMM type

C. This is a disruptive procedure that cannot be performed online.

D. Cache modules must be installed in CMG1

Correct Answer: A,B

Question 4

A VSP Е1090 customer wants to add another rack with Drive Boxes, however the new rack cannot be installed side-by-side with the controller rack. You plan to order SAS optical cables to connect the two racks together.
Which three cables lengths are available (in meters)? (Choose three.)

A. 30m

B. 5m

C. 10m

D. 50m

E. 100m

Correct Answer: A,C,D

Question 5

You are installing a new VSP G700 and are using the Initial Setup Wizard (ISW) for the network configuration. Which set of IP addresses is configured with the ISW?

A. IP addresses of management ports

B. IP addresses of all the ports

C. IP addresses of all the ports and of the SVP

D. IP addresses of maintenance ports

Correct Answer: A

Question 6

You need to replace a broken fan in a VSP E1090.
What is the correct procedure?

A. Use Storage Navigator for blocking the fan, then replace it.

B. Use the MPC for blocking the fan, then replace it.

C. Use the Maintenance Utility for stopping the fan, then replace it.

D. Remove the broken fan, then replace it.

Correct Answer: D

Question 7

Which three VSP Midrange storage arrays support hardware compression? (Choose three.)

A. VSP One B24

B. VSP E1090

C. VSP One B28

D. VSP One B26

E. VSP E990

Correct Answer: B,C,E

Question 8

Your customer wants to connect multiple servers to a new port on a VSP G700. The correct topology has already been set for the port.
What should you do next?

A. Scan for all WWNs.

B. Create a Host Group.

C. Enable Host Group security.

D. Enable Port Security.

Correct Answer: A

Welcome to TestSimulate

Hitachi Vantara Qualified Professional - VSP Midrange Family Installation (HQT-4180) Free Practice Test