HCIP-WLAN V2.0 (H12-323_V2.0) Free Practice Test

Question 1

In the Mesh networking of WLAN network, APs are connected by wireless. Compared with the traditional WLAN network where the AP uplink uses a wired network, which of the following is not an advantage of Mesh networking?

A. Flexible networking

B. Low network construction cost

C. Good anti-interference ability

D. Wide application scenarios, such as mines, docks, etc.

Correct Answer: D

Question 2

In WAC+FITAP networking, what is the default interval for CAPWAP tunnel heartbeat detection?
(Multiple choice)

A. 15

B. 30

C. 25

D. 10

Correct Answer: B,C,D

Question 3

A small enterprise uses Leader AP networking to deploy a WLAN network. If the user wants to improve network security, can they deploy an independent authentication server and configure external Portal authentication?

A. False

B. True

Correct Answer: B

Question 4

Which of the following is not a design principle for outdoor AP coverage when planning a WLAN network?

A. The recommended installation height for outdoor directional and omnidirectional antennas is 3-5 meters

B. Omnidirectional antenna coverage is recommended for open scenes such as squares or parks

C. Directional APs or antennas are recommended for roads around buildings

D. Outdoor omnidirectional antennas need to be installed horizontally

Correct Answer: D

Question 5

Huawei terminal dial test function is integrated in CloudCampus APP. After the terminal is associated with the wireless signal, open the terminal dial test tool in the APP to test. After the test is completed, the report can be exported on the Campusinsight platform

A. False

B. True

Correct Answer: B

Question 6

As shown in the figure, in the dual-link cold standby network, STA1 is a portal online user, the primary WAC currently connected to AP1 is WAC1, and STA1 goes online on WAC1 through AP1. Which of the following descriptions of this scenario are correct? (Multiple choice)

A. WAC2 has information about AP1, and the status of AP1 on WAC2 is standby.

B. WAC2 has information about AP1, and the status of AP1 on WAC2 is fault.

C. WAC2 has information about STA1, and the status of STA1 is unauthenticated.

D. There is no information about STA1 on WAC2

Correct Answer: B,D

Question 7

Which of the following options are correct about the wireless health assessment function of CampusInsight intelligent operation and maintenance platform? (Multiple choice)

A. The wireless health report is sent to users in the corresponding user group in PDF format. The report includes analysis of indicators such as access success rate, access time, throughput compliance rate, capacity health, signal and interference, and roaming compliance rate.

B. Detailed disclosure and diagnosis of key experience indicators, including the health of the experience indicator and various factors affecting the indicator.

C. Ranking different networks or different regions of the same network based on comprehensive experience evaluation to identify networks or regions with low overall health or low rankings in certain key indicators

D. The evaluation is mainly based on the following key indicators: access success rate, access time, coverage and interference, roaming compliance rate, capacity compliance rate, throughput compliance rate, AP forwarding efficiency

Correct Answer: A,B,C

Question 8

Which of the following devices has a built-in antenna? (Multiple choice)

A. AT815SN

B. AP8030DN

C. AP8130DN

D. AP6510DN

Correct Answer: A,B

Question 9

WLAN Planner supports 3D simulation function. Which of the following simulation modes does 3D building support when performing 3D simulation?

A. Free walking in walking mode

B. Rotation Mode

C. Walking Mode

D. Automatic walking in walking mode

Correct Answer: B

Question 10

Which of the following descriptions about roaming groups in inter-WAC roaming solutions is wrong?

A. When configuring a roaming group, ensure that the WAC has been configured with the CAPWAP source address, otherwise the roaming group will not take effect.

B. A maximum of 16 AC members can be added to a roaming group. The same WAC can join multiple roaming groups at the same time.

C. WACs in the same roaming group must use the same software version, otherwise roaming between WACs may fail.

D. Roaming group names must remain consistent between WACs

Correct Answer: B

Question 11

According to the free space signal attenuation model, signal strength is related to frequency distance. The higher the frequency, the greater the attenuation, and the farther the distance, the greater the attenuation.

A. False

B. True

Correct Answer: B

Question 12

When using WLAN Planner to merge projects, both the baseline project and the related projects must have floors before the projects can be merged, otherwise the merger will fail.

A. False

B. True

Correct Answer: A

Question 13

Drag and Drop Question
The figure shows a schematic diagram of the on-site engineering survey test obstacle attenuation. Please match the correct test content with the test steps.

Correct Answer:

Question 14

In Huawei's intelligent immersion solution, it is necessary to collect information about neighboring APs. The collection method only relies on the AP to listen to the Probe frame of the terminal, or the AP periodically switches channels and actively scans the terminal.

A. False

B. True

Correct Answer: A

Welcome to TestSimulate

Huawei HCIP-WLAN V2.0 (H12-323_V2.0) Free Practice Test