HCIP-Transmission V2.0 (H31-341-ENU) Free Practice Test

Question 1

The following description of the ASDN software structure, the correct ones are: (Multiple Choice)

A. The transmission plane refers to the traditional transmission network.

B. The management plane mainly refers to upper management such as network management.

C. Intelligent optical network consists of three planes

D. Intelligent software main application management plane

Correct Answer: A,B,C

Question 2

Which of the following description of the DM12 board are correct? (Multiple choice)

A. One DX1 board can be used with two DM12

B. Access the NX6bit/s and sub-rate service signals through the DB28 connector on the DM12 board.

C. Accessing G.703 64 kbit/s co-directional service signals through the DB44 interface on the DM12 board

D. Electrical signal input and output interfaces for DDN, Unframed E1 and sub-rate services

Correct Answer: A,B,C

Question 3

MG-SDH digital single core can be expanded by software upgrade.

A. False

B. True

Correct Answer: B

Question 4

In a typical chained NG WDM network (such as A -> B -> C, A, B, and C are three sites), it is found that the official telephone number between the stations is not available during the commissioning. What are the possible reasons? (Multiple choice)

A. B station SC2 board is damaged

B. C station receiving direction OA board damage

C. In the SC2 board configuration of station B, the configuration is incorrectly changed to "the official does not pass the optical port."

Correct Answer: A,C

Question 5

Path method creates OCh failure, what are the possible reasons? (Multiple Choice)

A. No service layer path

B. There are still unremoved alarms in the boards involved in OCh.

C. Inconsistent wavelength setting at both ends of source and sink

D. Some pigtails are not connected

Correct Answer: A,C,D

Question 6

Which of the following is a good way to avoid creating discrete paths? (Multiple Choice)

A. Guide users to learn business configuration specifications.

B. The service of the single-station configuration should perform path search on the network to ensure that the service configuration is complete and standardized.

C. The path with the protected route is to be broken or switched. Ensure that the configuration is complete and standardized.

D. Try to use the path function to configure.

Correct Answer: A,B,C,D

Question 7

A, C are the WDM OTM stations, and B is the relay station.
When the transmission direction of the A to B stations is interrupted, the Wavelength side of the B-stack OTU relay board reports the R_LOS emergency alarm and runs the processing to the upstream A.
The station side OTU2_BDI secondary alarm. At the same time, the alarm continues to be transmitted to the downstream station of the B station. After the alarm is processed at the C site, the ODU2_PM_AIS minor alarm is reported on the WDM side of the C-site OTU, and the ODU2_PM_BDI secondary alarm is transmitted back to the upstream station A.

A. FALSE

B. TRUE

Correct Answer: B

Question 8

Which of the following IP addresses are not part of the private IP address?

A. 192.168.0.1

B. 10.0.0.1

C. 172.128.0.1

D. 10.255. 0.1

Correct Answer: C

Welcome to TestSimulate

Huawei HCIP-Transmission V2.0 (H31-341-ENU) Free Practice Test