HCIP-Access V2.0 (H35-211) Free Practice Test

Question 1

In the ODN network, how large should the standard range of optical power attenuation in upstream and downstream be controlled?

A. 11db, 23db

B. 28.5db, 13db

C. 23db, 11db

D. 13db, 28.5db

Correct Answer: D

Question 2

About multicast, which of the following description is incorrect?

A. The common parameters of Layer 2 multicast protocols (IGMP Proxy and IGMP Snooping) are globally configured based on the device and are valid for all multicast VLANs.

B. When igmp match mode disable, you need to configure a multicast program group.

C. Report sent by the user is captured on the board logic and sent to the board CPU.

D. Add igmp user under BTV. By default, one multicast user can watch 8 programs.

Correct Answer: B

Question 3

Which type of traffic is marked yellow when traffic is scheduled on the MA5680T?

A. Traffic below CIR

B. Traffic above CBS

C. Traffic above CIR but below PIR

D. Traffic above PIR

Correct Answer: C

Question 4

The MA5600 system comes with four default ADSL line templates. Which of the following template numbers does not belong to the default line templates?

A. 1001

B. 1

C. 1002

D. 2

Correct Answer: D

Question 5

Is the following description correct?
In the PPP protocol, after the PPP authentication is successful, the Authenticate phase is transferred to the Network phase.

A. False

B. True

Correct Answer: B

Question 6

Which of the following are the general methods of XDSL fault location? (Multiple Choice)

A. Comparative Interchange Analysis

B. Statistical Analysis of System Resources

C. Loopback test analysis

D. Configuration data analysis

Correct Answer: A,B,C,D

Question 7

What does the ONT PON indicator light indicate?

A. The connection between the ONT and the OLT has been established

B. ONT received optical power is lower than optical receive sensitivity

C. ONT luminescence abnormality

D. ONT attempts to establish a connection with the OLT

Correct Answer: A

Question 8

Is the following description correct?
The MA5600T or MA5680T supports VLAN tag conversion. When SVLANs with different attributes pass through, when the service-port creates a service flow, such as the tag-transform is set to default, there is no difference in the tag conversion rule.

A. FALSE

B. TRUE

Correct Answer: A

Question 9

If there are multiple Set top boxes watching a multicast program at the same time under a single ONT (for example: HG8245), enabling the following function on the MA5608T for the ONT multicast user can ensure that when a set-top box switches channels, programs watched by other STBs are not affected influences?

A. prejoin

B. Quick leave based on MAC

C. preview

D. immediate departure

Correct Answer: B

Question 10

What methods can be used for fault location when PPPoE dial-up failure occurs in the Internet service? (Multiple Choice)

A. Check PITP configuration

B. Check whether an ACL that restricts PPPoE packets is configured

C. Check whether the device to user Modem is reachable

D. Check whether the circuit alarm template is reasonable

Correct Answer: A,B,C

Question 11

T.38 does not have an independent fax status and is completely dependent on the fax mechanism of T.30.

A. False

B. True

Correct Answer: B

Question 12

Which of the following is not included in the list tacked by ToolBox tool?

A. MGCP signaling trace

B. RTCP information

C. H248 signaling tracking

D. V5 Layer 2 message tracking

Correct Answer: B

Welcome to TestSimulate

Huawei HCIP-Access V2.0 (H35-211) Free Practice Test