Fast Track - Applying HPE FlexNetwork Fundamentals (HP2-Z37) Free Practice Test

Question 1

Refer to the exhibit.

All of the switches in the exhibit are running Multiple Spanning Tree Protocol (MSTP). The ports that connect to another switch are not boundary ports. All switches are configured as follows:
Config name = Region 1
Revision number = 1
Instance 1 =VLANs 10 and 12
Instance 2 = VLANs 11 and 13
Currently, only VLANs 1, 10, 11, 12,and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

A. No topology changes occur with spanning tree.

B. Switch_C enters a spanning-tree inconsistent state and blocks all ports.

C. Link load sharing is no longer in effect on Switch_C.

D. The ports that connect to other switches on Switch_C become boundary ports.

Correct Answer: A

Question 2

A device is connected to an HP Comware hybrid port. Which type of information from the attached device can be used to assign it to a VLAN?

A. access control list

B. protocol

C. LLDP device type

D. IPX host address

Correct Answer: B

Question 3

The exhibit shows the physical connection between two HP Comware switches and a server
The network administrator is concerned about redundancy and wants to implement a solution like that shown on the right side of the exhibit. The administrator plans to use an LACP link aggregation with both links active. What must the administrator do first?

A. Combine the switches into an Intelligent Resilient Framework (IRF) virtual switch.

B. Configure an LACP link aggregation between the switches.

C. Configure the same operational key on both the switches.

D. Enable dynamic link aggregation globally on the switches.

Correct Answer: D

Question 4

A network administrator is logging in to an HP Comware switch using Telnet. What is the default privilege level for this type of login?

A. manager (3)

B. monitor (1)

C. system (2)

D. visitor (0)

Correct Answer: A

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 5

A network administrator wants to discover an HP MultiService Mobility (MSM) AP in HP Intelligent Management Center (IMC). The MSM AP is operating in autonomous mode. What should the administrator do to ensure that IMC can discover the AP?

A. Configure the MSM AP Telnet settings to match the IMC login settings.

B. Load a certificate on the MSM AP and ensure that IMC trusts the certificate.

C. Load a Secure Shell (SSH) key on the MSM AP and match the IMC login settings.

D. Configure the MSM AP SNMP settings to match the IMC SNMP settings.

Correct Answer: D

Welcome to TestSimulate

HP Fast Track - Applying HPE FlexNetwork Fundamentals (HP2-Z37) Free Practice Test