Extreme Networks Specialist.... (EW0-300) Free Practice Test

Question 1

IP Version 6 has amongst other differences with IP Version 4 also different address length. What is the size of an IPv6 address?

A. 64 bits

B. 128 bits

C. 16 bits

D. 32 bits

Correct Answer: B

Question 2

According to accompanying diagram and ACL configuration it is possible to telnet from host A to any of the switch IP addresses.

A. False

B. True

Correct Answer: A

Question 3

Which option must be configured when running ESRP and Spanning Tree with the same VLAN on the same switch?

A. ESRP groups must be configured

B. ESRP host-attach must be configured

C. ESRP domains must be configured

D. ESRP and STP are not supported on the same VLAN on the same switch.

Correct Answer: D

Question 4

In a stable OSPF network, all OSPF routers in the same area must have the same LSDB contents.

A. False

B. True

Correct Answer: B

Question 5

When the CLI command show vlan corporate, is issued, the Protocol field has a value of NONE? Why is this so?

A. A protocol filter was added to this VLAN. That protocol filter was later deleted from the switch.

B. There is a system error, there is no such thing as a NONE in the protocol field

C. A protocol filter has not yet been configured for the vlan corporate

D. None of these.

Correct Answer: A

Question 6

Which statement is true about integrated IS-IS.

A. It is a dynamic routing protocol

B. Supports Pure-IP environments, Pure-OSI and dual environments

C. All of the above

D. Used to route both IP and OSI packets

Correct Answer: C

Question 7

Which of the following statements fit the description of PIM sparse mode? (choose three that apply)

A. An explicit join is not required in PIM sparse mode.

B. In PIM sparse mode the RPF check depends on the tree type

C. PIM sparse mode is suitable for network with minimal multicast deployment.

D. PIM sparse mode builds shared trees based on a common Rendez-Vous Point

Correct Answer: A,B,C,D

Question 8

In Extreme Ware what is the normal ACL behavior for incoming traffic when there is no default rule configured?

A. Implicit deny

B. Implicit permit

C. Explicit deny

D. Explicit permit

Correct Answer: B

Question 9

When a PIM-SM router wants to receive a Multicast stream, it

A. Sends a join in the direction of the RP.

B. Sends a Join in the direction of the group-address, using the RPF-check

C. Sends out a Join on all its multicast enabled interfaces

D. Sends a Join in the direction of the BSR

Correct Answer: A

Question 10

Which CLI command enables all multicast traffic to multicast routers only?

A. enable igmp snooping

B. enable igmp snooping forward-mcrouter-only

C. enable igmp snooping vlan mcrouters

D. enable igmp

Correct Answer: B

Welcome to TestSimulate

Extreme Networks Specialist.... (EW0-300) Free Practice Test