Extreme networks associate(ena) (EW0-200) Free Practice Test

Question 1

Exhibit:

After using the disable web command you later issue the show session command and see the following How was it possible for someone to login with ExtremeWare Vista?

A. You did not save the configuration after issuing the DISABLE WEB command.

B. The disable web command does not exist.

C. Admin level accounts can always login through console, telnet, and HTTP.

D. You did not reboot after issuing the DISABLE WEB command.

Correct Answer: D

Question 2

An Extreme Switch is shipped with a pre-configured VLAN called DEFAULT that has all switch ports as tagged members.

A. FALSE

B. TRUE

Correct Answer: A

Question 3

Exhibit:

What can possibly cause the error displayed in the exhibit?

A. An attempt was made to add a port to a port-based VLAN, where that port was already in use by another port-based VLAN.

B. All of the above.

C. An attempt was made to create another tagged VLAN for port 1.

D. An attempt was made to add an IP address to port 1 when it was already configured with a protocol filter.

Correct Answer: A

Question 4

What is the default area type for all OSPF areas created using the ExtremeWare CLI create ospf area <area identifier>?

A. None of these

B. Normal

C. NSSA

D. Stub

Correct Answer: B

Question 5

BGP, OSPF and RIP are interior gateway protocols supported by ExtremeWare.

A. FALSE

B. TRUE

Correct Answer: A

Question 6

Which of the following CLI commands would you use to enable ECMP for RIP?

A. None of these, ecmp is not supported by RIP

B. enable iproute sharing

C. enable route sharing rip

D. enable rip route sharing

Correct Answer: A

Question 7

In addition to maintaining an internal log, ExtremeWare supports remote logging feature via the UNIX syslog facility.

A. FALSE

B. TRUE

Correct Answer: B

Question 8

Which of the following can generate route entries for the IP route table to become populated?

A. RIP

B. UDP-forwarding

C. proxy ARP

D. None of these.

Correct Answer: A

Question 9

Which CLI command would you use to create a default route with a metric of 5 and a gateway of 10.0.0.1?

A. CONFIG IPROUTE ADD DEFAULT 5 10.0.0.1

B. CONFIG IPROUTE ADD DEFAULT 10.0.0.1 5

C. CREATE IPROUTE ADD DEFAULT 10.0.0.1 5

D. CREATE IPROUTE ADD DEFAULT 5 10.0.0.1

Correct Answer: B

Welcome to TestSimulate

Extreme Networks Extreme networks associate(ena) (EW0-200) Free Practice Test