Enterprise Routing and Switching, Specialist (JNCIS-ENT) (JN0-347) Free Practice Test

Question 1

Which statement is true about load balancing of equal cost paths?

A. The route preference parameter must be manually set to the same value.

B. The maximum-paths parameter must be configured under the routing-options hierarchy.

C. A load-balancing policy must be configured under the policy-options hierarchy.

D. Traffic is balanced across equal cost paths by default.

Correct Answer: D

Question 2

Click the Exhibit button.

A routing table contains multiple BGP routes to the same destination prefix. The route preference is the same for each route.
Referring to the exhibit, which route would be selected?

A. route D

B. route C

C. route A

D. route B

Correct Answer: A

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 3

Click the Exhibit button. Referring to the exhibit, what does the asterisk (*) following the ge-0/0/5.0 interface indicate?

A. It indicates the interface is not active.

B. It indicates the interface is active.

C. It indicates the interface is a trunk port.

D. It indicates the interface is an access port.

Correct Answer: B

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 4

Click the Exhibit button. You are notified that clients connected to your EX Series switch are not receiving IP addresses from the DHCP server.
You examine the switch configuration and notice that DHCP snooping has been enabled. In this scenario, what would cause the problem?

A. The DHCP relay setting in the forwarding-options hierarchy has not been configured.

B. The dynamic ARP inspection feature needs to be enabled on the ge-0/0/0 interface.

C. The DHCP server's ge-0/0/0 interface has not been configured as a trusted interface.

D. The location information is not being inserted into the DHCP option 82 requests.

Correct Answer: B

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 5

Which two values are used to generate a bridge ID when using STP? (Choose two.)

A. system MAC address

B. loopback IP address

C. bridge priority

D. port identifier

Correct Answer: A,C

Question 6

You are adding a new EX4300 member switch to your existing EX4300 Virtual Chassis. However, the new member is not running the same Junos version as the other members.
By default, what is the expected behavior?

A. The Virtual Chassis will transition into a split brain situation between the existing master Routing Engine and the switch running the different version.

B. The new switch is not recognized by the Virtual Chassis.

C. The new switch will automatically pull the correct version from the master Routing Engine and perform the necessary upgrade.

D. The new switch will be assigned a member ID and then placed in an inactive state.

Correct Answer: C

Welcome to TestSimulate

Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) (JN0-347) Free Practice Test