Design Point (PTP and PMP) Solutions (MSC-111) Free Practice Test

Question 1

Which product provides the best (lowest) latency?

A. FTP600

B. FTP300

C. FTP100

D. FTP800

E. All the above provide the same latency

Correct Answer: D

Question 2

Microwave Point to Point systems can be susceptible to Multi-path cancellation. Which technology can help mitigate Multi-Path?

A. RF port replication

B. IEEE 802.3AF

C. OFDM (Orthogonal Frequency Division Duplex)

D. Transmit time diversity

Correct Answer: C

Question 3

When deploying PMP DFS (Dynamic Frequency Selection) equipment in an area where weather radar installations are present, what additional planning is necessary (select
TWO)?

A. Ensure CMM GPS timing is used on all APs to avoid false radar triggers

B. Careful selection of mounting locations for APs that are in close proximity to the radar installation

C. Ensure power outputs on APs are below power output of weather radar systems

D. Frequency planning to avoid radar channels

E. On all DFS APs, use spectrum scanning to identify the type of radar signatures. Then set the signature types in the DFS settings page.

Correct Answer: B,D

Question 4

A customer has a number of PMP business clients, located 8 km (5 miles) away from a tower. The SMs are operating in lx mode using equipment at the maximum allowable EIRP.
What would be required to provide service in 2x or 3x mode to these clients?

A. Install narrow beam-width antennas at the client sites

B. Disable lx mode and only allow 2x and 3x mode

C. Install new SM equipment with output greater then the allowable EIRP and lower the AP power output accordingly.

D. Install an additional PMP cluster close enough to the clients to provide 2x or 3x service

Correct Answer: D

Question 5

The FTP800 1+1 configuration allows you to:

A. deploy two PTP800 radios on the same antenna, with one radio as a hot standby.

B. deploy two FTP800 radios on two different antennas, with both radios used to increase the total throughput.

C. deploy two FTP800 radios on the same antenna, with both radios used to increase the total throughput.

Correct Answer: A

Question 6

With regard to Motorola's recommendations, what is the maximum number of APs you can deploy in a FSK cluster with integrated antennas?

A. 3 APs

B. 6 APs

C. 7 APs

D. 4 APs

Correct Answer: B

Question 7

Thermal Ducting is a phenomenon often seen over great distances of water and flat hot terrain. It is the layering of different density air in the atmosphere and can cause significant signal fading. One possible solution to Thermal Ducting is to:

A. use two physically separated single polarized antennas (also known as Space Diversity)

B. deploy a Dual Polarity antenna at both ends of a link.

C. increase frequency to increase free space attenuation.

D. deploy a single polarization microwave system.

Correct Answer: A

Question 8

The reflection of a radio wave can affect the link quality:

A. positively ONLY

B. it does not affect link quality

C. negatively ONLY

D. either negatively or positively

Correct Answer: D

Question 9

Which one of the following choices can be modeled using Broadband Planner?

A. Outdoor Mesh and PMP

B. Outdoor Mesh and FTP

C. Indoor VVLAN

D. Indoor VVLAN and Outdoor Mesh

Correct Answer: A

Welcome to TestSimulate

Motorola Solutions Design Point (PTP and PMP) Solutions (MSC-111) Free Practice Test