Deploying Cisco Service Provider Mobile Backhaul Solutions (500-201) Free Practice Test

Question 1

You have configured your Cisco ASR 901 on the network, created a loopback interface for use with PTP, and assigned the address as a PTP source interface.
Why are you unable to ping the interface address?

A. The interface is shut down and therefore not pingable. Issue the no shut command on the interface.

B. The loopback addresses on a Cisco ASR 901 are not pingable.

C. There is no reason for the interface to not ping; there must be a routing issue.

D. The loopback addresses assigned as a PTP clock source are not pingable.

Correct Answer: D

Question 2

Assume that the cell site is located in an urban area.
In a fixed-mobile convergence use-case, what keeps the route scale of the RAN access to a minimum?

A. egress filtering towards the node Bs

B. egress provisioning with the MTG node

C. egress filtering on the inbound route filter

D. egress filtering on the pre-aggregation node inline-RR

Correct Answer: D

Question 3

In the BGP transport layer and in the LTE VPN, which action is important?

A. to deny prefixes for services already configured

B. to filter prefixes as widely as possible

C. to filter prefixes as precisely as possible

D. to allow prefixes for all access areas, and to facilitate X2 interface transport

Correct Answer: C

Question 4

Which TDM pseudowire protocol would an engineer use to combine DS0 from different T1 circuits?

A. CESoPSN

B. SAToP

C. ATM over MPLS

D. Ethernet

Correct Answer: A

Question 5

Which scale profile is Cisco UMMT Model 1.2 designed to support?

A. more than 100,000 nodes

B. 10,000 to 100,000 nodes

C. up to 1000 nodes

D. 1,000 to 10,000 nodes

Correct Answer: C

Welcome to TestSimulate

Cisco Deploying Cisco Service Provider Mobile Backhaul Solutions (500-201) Free Practice Test