Dell Networking Foundations 2023 (D-NWG-FN-23) Free Practice Test

Question 1

Two OS10 switches reside within a VLT domain with statically configured primary-priorities. The current primary peer, switch OS10-A, has a priority of 100, while the secondary peer, OS10-B, has a priority of 200.
If OS10-A reboots and comes back online, what roles will the VLT peers be assigned?

A. OS10-A will be primary and OS10-B will be secondary.

B. OS10-A will be secondary and OS10-B will be master.

C. OS10-A will be secondary and OS10-B will be primary.

D. OS10-A will be standby and OS10-B will be primary.

Correct Answer: C

Question 2

Which command is used to create a non-default VRF instance?

A. ip vrf forwarding vrf-test

B. ip vrf

C. ip vrf forwarding new-vrf

D. interface ethernet 1/1/1

Correct Answer: B

Question 3

Refer to the exhibit.

The output shown is from which command?

A. S3(config-router-ospf-1)# show ip ospf lsa

B. S3(config-router-ospf-1)# show ip ospf database

C. S3(config-router-ospf-1)# show ip ospf topology

D. S3(config-router-ospf-1)# show ip ospf statistics

Correct Answer: B

Question 4

A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?

A. There was no issue; this is normal behavior.

B. One of the upstream interfaces is an uplink-state group went down.

C. Spanning tree Loop-guard was implemented on the uplink-state group.

D. Both a port channel and its members were assigned to an uplink-state group.

Correct Answer: C

Question 5

How are multiple hardware based ACLs filtered?

A. IP

B. DHCP

C. NTP

D. NPU

Correct Answer: D

Question 6

In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?

A. The node is used to provide IGMP snooping across a layer 3 boundary.

B. The root node of the shared tree topology is used to provide routing between the source and receiver.

C. The root node of the source tree topology is used to provide routing between the source and receiver.

D. The node is used to provide IGMP snooping on a layer 2 shared segment.

Correct Answer: B

Welcome to TestSimulate

EMC Dell Networking Foundations 2023 (D-NWG-FN-23) Free Practice Test