Dell Networking Associate Exam (DCAN-100) Free Practice Test

Question 1

Refer to the output:

A technician creates a new fiber connection to the switch. The transceivers and cable are plugged in at both ends. The connection is in a link down state.
What is causing the issue?

A. There is a duplex mismatch.

B. The cable is inverted.

C. The local transceiver is not sending power.

D. Autonegotiation is failing.

Correct Answer: B

Question 2

Which switchport command must be applied to an interface to allow Voice VLAN configurations?

A. Switchport dot1q ethertype 802.1Q

B. Switchport mode trunk

C. Switchport voice detect auto

D. Switchport mode general

Correct Answer: C

Question 3

Refer to the output.

Which two actions occur if interface Tw2/0/2 goes down? (Choose two.)

A. Switch 1 becomes a standalone switch.

B. Switch 3 becomes a standalone switch.

C. Switch 3 remains in the stack.

D. Switch 2 remains in the stack.

E. Switch 2 becomes a standalone switch.

Correct Answer: C,D

Question 4

Which of the following is an IPv4 address?

A. 172.16.225.0/23

B. 192.168.0.3/30

C. 224.0.0.3/8

D. 10.0.0.255/16

Correct Answer: D

Question 5

Refer to the exhibit.

A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The new switch routing table is NOT populating even after the correct network statements are added.
What is causing this issue?

A. The new N-Series switch does not have "default-information originate" configured.

B. The existing switch has been configured for "hostroutesaccept".

C. The other switch is a root bridge and cannot form RIP relationships.

D. The existing switch is configured to send and receive only for RIPv1.

Correct Answer: D

Question 6

What are two commonly deployed PoE powered devices? (Choose two.)

A. Managed Ethernet router

B. A printer

C. A Workstation

D. VoIP phone

E. Wireless access point

Correct Answer: D,E

Question 7

Which two methods will create a VLAN on N-Series switches? (Choose two.)

A. console(config)#interface vlan 11

B. console#vlan 11

C. console(config)#interface gi1/0/1console(config-if-Gi1/0/1)#switchport access vlan 10

D. console(config)#interface gi1/0/1console(config-if-Gi1/0/1)# vlan 10

E. console(config)#vlan 11

Correct Answer: C,E

Welcome to TestSimulate

Dell Networking Associate (DCAN-100) Free Practice Test