Cisco Certified Network Associate (200-125) Free Practice Test

Question 1

Which two EtherChannel PAgP modes can you configure? (choose two)

A. passive

B. on

C. active

D. desirable

E. auto

Correct Answer: D,E

Question 2

Which option is the default switch port port-security violation mode?

A. protect

B. restrict

C. shutdown

D. shutdown vlan

Correct Answer: C

Question 3

Which statement about native VLAN traffic is true?

A. Traffic on the native VLAN is tagged with 1 by default

B. Control plane traffic is blocked on the native VLAN.

C. Cisco Discovery Protocol traffic travels on the native VLAN by default

D. The native VLAN is typically disabled for security reasons

Correct Answer: C

Question 4

What is the default Syslog facility level?

A. local 7

B. local 4

C. local 6

D. local 5

Correct Answer: A

Question 5

Which route source code represents the routing protocol with a default administrative distance of 90 in the routing table?

A. D

B. O

C. R

D. S

E. E

Correct Answer: A

Question 6

Under which circumstance is a router on a stick most appropriate?

A. When a router have multiple interface on single physical links.

B. When a router have multiple subnets on a single physical link.

C. When a router have single interface on multiple physical links.

D. When a router have single subnet on multiple physical links.

Correct Answer: B

Question 7

Which command enables RSTP on a switch?

A. spanning-tree backbonefast

B. spanning-tree uplinkfast

C. spanning-tree mode rapid-pvst

D. spanning-tree mode mst

Correct Answer: C

Question 8

Which three statements about HSRP operation are true? (Choose three.)

A. The HSRP default timers are a 3 second hello interval and a 10 second dead interval.

B. The virtual IP address and virtual address are active on the HSRP Master router.

C. The HSRP virtual IP address must be on a different subnet than the routers' interfaces on the same LAN.

D. HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing

E. HSRP supports only clear-text authentication.

F. The HSRP virtual IP address must be the same as one of the router's interface addresses on the LAN.

Correct Answer: A,B,D

Question 9

Which two operational modes are supported on the members of a StackWise switch stack? (Choose two)

A. passive

B. redundant

C. power-sharing

D. active

E. standby

Correct Answer: D,E

Question 10

Examine R2 configuration, the traffic that is destined to R3 LAN network sourced from Router R2 is forwarded toR1 instead R3.
What could be an issue?
R2#traceroute 10.10.12.1 source 10.10.10.1
Type escape sequence to abort.
Tracing the route to 10.10.12.1
VRF info: (vrf in name/id, vrf out name/id)
1 172.16.14.10 msec 1 msec 0 msec
2 172.16.14.1! H! H *
R2#

A. No issue that is identified; this behavior is normal since default route propagated intoRIPv2 domain by Router R1.

B. RIPv2 routing updates are suppressed between R2 and R3using passive interface feature.

C. RIPv2 enabled on R3, but R3 LAN network that is not advertised into RIPv2 domain.

D. RIPv2 not enabled on R3.

Correct Answer: D

Question 11

Which function does traffic shaping perform?

A. it buffers traffic without queuing it

B. it drops packets to control the output rate

C. it bufers and queues excess packets

D. it queues traffic without buffering it

Correct Answer: C

Question 12

After you configure the ip dns spoofing command globally on a device, under which two conditions is DNS spoofing enabled on the device? (choose two)

A. The ip dns spoofing command is disabled on the local interface

B. The ip host command is disabled

C. The DNS server queue limit id disabled

D. The no ip domain lookup command is configured

E. All configured IP name server addresses are removed

Correct Answer: D,E

Welcome to TestSimulate

Cisco Certified Network Associate (200-125) Free Practice Test