Cisco and NetApp FlexPod Design Specialist (NS0-175) Free Practice Test

Question 1

Refer to the exhibit.

What would be the correct configuration for the ports labeled?

A. vlan 35fcoe vsan 45int eth1/31-32channel-group 15 mode activeint po15switchport mode trunkswitchport trunk allowed vlan 35switchport trunk allowed vsan 45spanning-tree port type edge trunkvsan databasevsan 45 interface po15

B. vlan 35fcoe vsan 45int eth1/31-32channel-group 15 mode activeint po15switchport access vlan 35int vfc15bind interface po15switchport trunk allowed vsan 45vsan databasevsan 45 interface vfc15

C. int eth1/31-32channel-group 15 mode activeint po15switchport mode access vsan 45vsan databasevsan 45 interface po15

D. vlan 35fcoe vsan 35int eth1/31channel-group 15 mode activeint eth 1/32channel-group 15 mode activeint portchannel15switchport mode trunkswitchport trunk allowed vlan 35spanning-tree port type edge trunkint vfc15bind interface po15switchport trunk allowed vsan 35vsan databasevsan 35 interface vfc15

E. int eth1/31channel-group 15 mode activeint eth 1/32channel-group 15 mode activeint po15switchport mode trunkswitchport trunk allowed vsan 45spanning-tree port type edge trunkvsan databasevsan 45 interface po15

Correct Answer: D

Question 2

What are three ways to configure a UCS 5108 server chassis power supply? (Choose three.)

A. pooled

B. n+n redundant

C. n+1 redundant

D. grid redundant

E. non redundant

Correct Answer: C,D,E

Question 3

Which of the following occurs when the diag dump command is selected?

A. The existing diagnostics file is overwritten.

B. The diagnostics file is automatically sent to NetApp support.

C. An Autosupport message is generated.

D. A new diagnostics file is created.

Correct Answer: D

Question 4

Which Microsoft Hyper-V and System Center VMM feature allows for creation of multiple VM networks on top of a logical network and allows for tenant use of overlapping IP addresses?

A. Load Balancer Integration

B. Stateless Transport Protocol

C. VLAN-based configuration

D. Network Virtualization

Correct Answer: D

Question 5

The FlexPod Data Center with VMware vSphere 5.1 solution utilizes a clustered file system that allows multiple hosts simultaneous read and write access to a single volume.
What is the name of this file system?

A. NTFS

B. VMFS

C. VHDX

D. FAT

Correct Answer: B

Question 6

A customer wants a low latency and high IOPS FlexPod solution and decides on an end-to-end NVMe design.
In this scenario, which three components are required to accomplish this task? (Choose three.)

A. Cisco UCS Virtual Interface Card (VIC) 1400 series

B. NetApp AFF with a 32Gbps FC HBA

C. Cisco Application Policy Infrastructure Controller (APIC)

D. Cisco MDS Series switches

E. NetApp FAS with a 32Gbps FC HBA

Correct Answer: A,B,D

Question 7

A complete listing of Network Appliance support centers is available at _____.

A. ftp.netapp.com

B. now.netapp.com

C. www.netapp.com

D. NetCache online help

Correct Answer: B

Question 8

Which port type would you configure when you connect a chassis to the Fabric Interconnects?

A. server ports

B. Fibre Channel storage ports

C. appliance ports

D. Ethernet uplink ports

Correct Answer: A

Question 9

What are three capabilities of Config Advisor as it pertains to a FlexPod solution? (Choose three.)

A. Hyper-V validation

B. hardware validation

C. firmware recommendations

D. configuration validation

E. firmware download

Correct Answer: B,C,D

Question 10

You are designing a new distributed environment of FlexPod systems across the entire organization. You will need to support FlexPod systems in two data centers and FlexPod with Cisco UCS Mini in your five manufacturing plants.
What are two benefits of deploying UCS Central in this scenario? (Choose two.)

A. It enables management of multiple UCS domains.

B. It improves the performance of each UCS domain.

C. It allows consistent configuration of global policies.

D. It enables a highly available environment.

Correct Answer: B,D

Welcome to TestSimulate

Network Appliance Cisco and NetApp FlexPod Design Specialist (NS0-175) Free Practice Test