Building the Cisco Cloud with Application Centric Infrastructure (300-475) Free Practice Test

Question 1

Which two guidelines or restrictions are valid when using traceroute? (Choose two.)

A. Traceroute only supports endpoint-to-endpoint mode.

B. A traceroute that is initiated from the tenant endpoints shows the default gateway as an intermediate hop that appears at the ingress leaf switch.

C. The traceroute source and destination IP addresses are configured as a combination of IPv4 and IPv6 addresses.

D. When the traceroute source or destination is an endpoint, the endpoint must be dynamic and not static.

Correct Answer: B,D

Question 2

In Cisco ACI, if no contract is attached to the EPG, what is the default behavior?

A. All ICMP packets are allowed in inter-EPG communication.

B. Unidirectional traffic is allowed for all protocols in inter-EPG communication.

C. Inter-EPG communication is disabled.

D. All TCP ports are allowed in inter-EPG communication.

Correct Answer: B

Question 3

Which two planes are involved in the discovery of hypervisor hosts on the Cisco ACI? (Choose two.)

A. control

B. data

C. HSRP

D. LLDP

E. management

Correct Answer: A,B

Question 4

In Cisco ACI, general steps are required to create an Application Network Profile. In Cisco ACI, general steps are required to create an Application Network Profile.
Which order should the configuration be done?
1) Create connection points between EPGs by using policy constructs.
2) Create policies to define connectivity with permit, deny, log, and
so on.
3) Create EPGs.

A. 3, 2, 1

B. 1, 2, 3

C. 2, 3, 1

D. 1, 3, 2

Correct Answer: A

Question 5

Cisco APICs utilize sharding to provide what function for an ACI fabric?

A. It provides horizontal scaling ability for policy management on APICs

B. It provides replication of application network policies across the APICs in the cluster

C. It provides scalability and reliability to the data sets generated and processed by the Distributed Policy Repository, the endpoint registry, the Observer, and the Topology Manager

D. It provides a method for determining which APIC will act as the master in a fabric during the election process

Correct Answer: C

Question 6

In Cisco ACI, which three statements are true about endpoints and endpoint groups? (Choose three.)

A. An EPG can be statically configured by an administrator in the Cisco APIC, or dynamically configured by an automated system such as vCenter or OpenStack.

B. An EPG can only be configured statically by an administrator in the Cisco APIC.

C. Endpoints have an address (identity), a location, attributes (such as version or patch level), and can be physical or virtual.

D. EPGs contain endpoints that have common policy requirements such as security, virtual machine mobility, QoS, or Layer 4 to Layer 7 services.

E. Endpoints have attributes and can only be virtual.

F. Policies are applied to individual endpoints rather than EPGs for better efficiency.

Correct Answer: A,C,D

Question 7

Assuming that a service device you are integrating into the Cisco ACI is dedicated to one tenant, where should you configure the logical device and associated concrete devices?

A. within the management tenant

B. on the service device itself

C. within the tenant context

D. in the device's base hypervisor UI

Correct Answer: C

Welcome to TestSimulate

Cisco Building the Cisco Cloud with Application Centric Infrastructure (300-475) Free Practice Test