A. Priority

B. Ratio

C. Round Robin

D. Observed

A. Configuration changes can only be made on the active system.

B. Virtual server addresses are hosted only by the active system.

C. Floating self-IP addresses are hosted only by the active system.

D. Fail-over triggers only cause changes on the active system.

E. Monitors are performed only by the active system.

A. The ifconfig -a command displays the floating addresses on the active system.

B. The bigtop command displays the status.

C. The status (Active/Standby) is embedded in the command prompt.

D. Only the active system's configuration screens are active.

A. The presence or absence of voltage over the fail-over cable takes precedence over network fail-over.

B. Either a network failure or loss of voltage across the fail-over cable will cause a fail-over.

C. A network failure will not cause a fail-over as long as there is a voltage across the fail-over cable.

D. The fail-over cable status is ignored. Fail-over is determined by the network status only.

A. The active system will reboot and the standby system will go into active mode.

B. The active system will fail-over and the standby system will go into active mode.

C. The active system will restart the traffic management module to eliminate the possibility that BIG-IP is the cause for the network failure.

D. The active system will note the failure in the HA table.

A. The pool members?SSL certificates must only exist.

B. The pool members?SSL certificates must be created within the company hosting the BIG-IPs.

C. The pool members?SSL certificates must be issued from a certificate authority.

D. No SSL certificates are required on the pool members.

A. create required pools, create a custom HTTP profile, create the iRule, create the Virtual Server

B. create a custom HTTP profile, create required pools, create the Virtual Server, create the iRule

C. create profiles, create the iRule, create required pools, create the Virtual Server

D. create the Virtual Server, create required pools, create the iRule, edit the Virtual Server

A. Some virtual servers could be associated with SNAT pools and others not associated with SNAT pools.

B. A SNAT for all addresses could be defined, and then disable the SNAT processing for select VLANs.

C. The decision to perform source address translation is always based on a client's address (or network). Thus, this goal cannot be achieved.

D. The decision to perform source address translation is always based on VLAN. Thus, the goal cannot be achieved.

A. All open connections will be maintained.

B. All open connections are lost, but new connections are initiated by the newly active BIG-IP, resulting in minimal client downtime.

C. Long-lived connections such as Telnet and FTP will be maintained while short-lived connections such as HTTP will be lost.

D. The "Mirror" option must be chosen on the NAT and the setting synchronized prior to the connection establishment.

E. All open connections will be lost.

A. priority values

B. ratio values

C. health monitors

D. load-balancing mode

E. connection limits