Associate - Networking Exam (DEA-5TT2) Free Practice Test

Question 1

A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?

A. Load balanced using a hash function

B. Interfaces will be used in active/passive

C. Traffic overflow will be sent to the second interface

D. Load balanced per packet using round robin

Correct Answer: A

Question 2

A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?

A. fd01::/64

B. ff02::/8

C. fe08::/64

D. fe80::/64

Correct Answer: D

Question 3

A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

A. 255.255.255.254

B. 255.255.255.248

C. 255.255.255.252

D. 255.255.255.256

Correct Answer: C

Question 4

Which IEEE standard defines the Data Link Layer, Discovery protocol?

A. 802.1W

B. 802.1D

C. 802.1AB

D. 802.1AX

Correct Answer: C

Question 5

Which message is sent by a router when TTL expires?

A. Echo reply

B. Echo request

C. Time exceeded

D. Destination unreachable

Correct Answer: C

Question 6

Which port and protocol is used by NTP to communicate?

A. TCP port 123 for the source and TCP port 80 for the destination

B. UDP port 123 for the source and TCP port 80 for the destination

C. TCP port 123 for both the source and destination

D. UDP port 123 for both the source and destination

Correct Answer: D

Question 7

A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

A. Switch duplicates the packet and sends it to all interfaces.

B. Switch replies back to the source with an ICMP Reject packet.

C. Switch checks its routing table and forwards the packet accordingly.

D. Switch drops the packet.

Correct Answer: C

Welcome to TestSimulate

EMC Associate - Networking (DEA-5TT2) Free Practice Test