ASQ Certified Quality Inspector (CQI) Free Practice Test
Question 1
The overall ability of two or more operators to obtain consistent results repeatedly when measuring the same set of parts and using the same measuring equipment is the definition of Response:
Correct Answer: C
Question 2
How many cm in 2.6 feet?
Response:
Response:
Correct Answer: B
Question 3
What are the mean, median, and mode for the following sample?
6, 7, 8, 8, 10, 12
Response:
6, 7, 8, 8, 10, 12
Response:
Correct Answer: D
Question 4
The blueprint for the top view is given as follows:
Of the other views below which is an incorrect view? Response:
Of the other views below which is an incorrect view? Response:
Correct Answer: D
Question 5
Software Requirements Traceability Matrix
This Software Requirements Traceability Matrix for a satellite is an example of which of the following:
I) Software flow chart II) Functional checks chart III) Software verification test IV) 100% software inspection verify that command times of 0.1, 0.2, 5.0, 9.9 and 10.0 seconds are included in tests. Inspect time tags in their output streams. Response:
This Software Requirements Traceability Matrix for a satellite is an example of which of the following:
I) Software flow chart II) Functional checks chart III) Software verification test IV) 100% software inspection verify that command times of 0.1, 0.2, 5.0, 9.9 and 10.0 seconds are included in tests. Inspect time tags in their output streams. Response:
Correct Answer: C
Question 6
An inspector is checking a plastic part for surface defects. Which of these testing methods would work?
Response:
Response:
Correct Answer: A
Question 7
An oscilloscope is best described as an instrument to analyze:
I) If an electrical component is working
II) Power source to see if there is noise on the line or if the line is clean Response:
I) If an electrical component is working
II) Power source to see if there is noise on the line or if the line is clean Response:
Correct Answer: A
Question 8
If the capability index (Cp) of a process is less than 1.00, this generally means:
Response:
Response:
Correct Answer: B
Question 9
You are taking an inventory of dial indicators in an inspection shop and notice one that has a yellow face. What does this tell you?
Response:
Response:
Correct Answer: A
Question 10
Which of the following shapes of the indenter tip of a hardness tester for metal is associated with the Rockwell test method?
Response:
Response:
Correct Answer: C
Question 11
Which of the following does Process capability measurement provide?
Response:
Response:
Correct Answer: C
Question 12
A standard micrometer will have how many pitch threads per inch?
Response:
Response:
Correct Answer: B
Question 13
Which of the following measurement technique applications is a telescoping gauge that is subsequently measured with calipers used for?
Response:
Response:
Correct Answer: B
Question 14
Which of the following is not a typical problem of poor data collection?
Response:
Response:
Correct Answer: B