Aruba Certified Switching Associate Exam (HPE6-A41) Free Practice Test

Question 1

Refer to the exhibit.
Exhibit 1.

Exhibit 2.

Assume that Switch-2 is correctly configured for OSPF.
Which additional step must the administrator take to enable Switch-1 to advertise 192.168.2.0/24 to Switch-2?

A. Set a router ID on Switch-1.

B. Add Switch-2's router ID to Switch-1's OSPF neighbor list.

C. Enable OSPF on VLAN 2.

D. Configure a route to advertise 192.168.2.0/24 on Switch-1.

Correct Answer: C

Question 2

A network administrator uses the console to access an ArubaOS core switch and wants to find the management IP address of another ArubaOS switch that is currently connected to port B1. Which information should the administrator review?

A. device profile with the use of the show device-profile status command

B. interface with the use of the show interface command

C. LLDP with the use of the show lldp info remote-device command

D. ARP with the use of the show arp command

Correct Answer: C

Question 3

What often happens when a Layer2 broadcast domain has a loop?

A. In the switch MAC tables, the MAC addresses frequently move from one port to another.

B. Switches automatically raise their MSTP configuration revision level by one.

C. In the switch routing tables, some routes converge with new metrics.

D. Some switch-to-switch ports take the MSTP alternative role and stay in that role.

Correct Answer: A

Question 4

Refer to the exhibit.

This switch currently assigns all VLANs to MSTP instance 0 or the Internal Spanning Tree (IST).
Which statement correctly describes interface 21?

A. The interface does not forward or accept data traffic, but it is ready to start forwarding if interface 19 fails.

B. The interface is down at Layer 2; it is not available for sending or receiving any traffic.

C. The interface is an edge port but has received Bridge Protocol Data Units (BPDUs), so it is disabled.

D. The interface does not support spanning tree: it is possible that it will introduce a loop in the network.

Correct Answer: A

Question 5

A network administrator wants to deploy Aruba Instant APs (IAPs) at a remote site that does not have Internet access. The APs should receive their configuration automatically from AirWave by using Zero Touch Provisioning (ZTP). What does the administrator need to configure?

A. the name and password of a user with full administrative rights to AirWave

B. the IP address for the DNS server with the mapping for the airwave hostname

C. the DHCP server configured with options 43 and 60 for ZTP

D. the name of the AirWave VLAN with the configuration that the APs should use

Correct Answer: C

Question 6

What is the relationship between a wireless client's data rate and the throughput for the client's traffic?

A. The throughput is 90 percent of the data rate.

B. The data rate and the throughput are equivalent.

C. The throughput is less than the data rate and also depends on factors such as number of clients in the cell.

D. The throughput is equal to the data rate multiplied by the connection time, minus the headers' bytes.

Correct Answer: D

Question 7

Refer to the exhibit.

A network administrator wants to set up a link aggregation between two switches, as shown in the exhibit. The link aggregation must meet these requirements:
* Protects against misconfiguration
* Can be configured with VLANs and other settings
Which type of link aggregation should the administrator create?

A. static LACP

B. distributed (trunk)

C. dynamic LACP

D. manual (trunk)

Correct Answer: A

Welcome to TestSimulate

HP Aruba Certified Switching Associate (HPE6-A41) Free Practice Test