Aruba Certified Mobility Professional 6.0 (ACMP) Free Practice Test

Question 1

A user connected to a Captive Portal VAP successfully. When the user opens their browser and tries to access their homepage, they get redirected as expected to another URL on the Aruba Controller. However, they see an error message that web authentication has been disabled. What might be a cause of this?

A. An initial role has not been assigned to the AAA profile

B. A server group has not been assigned to the captive portal profile

C. The Captive portal profile has not been assigned to the AAA profile

D. The Captive portal profile has not been assigned to the initial role

Correct Answer: D

Question 2

An AP was configured to use dynamic controller discovery and assigned to an AP group, then powered off for over a week. When the AP is redeployed, what previous configuration will it retain?

A. It's Serial Number

B. The controllers IP address

C. The controller IP address and the AP Group

D. It's AP name and AP Group

E. After a few days all configurations is lost

Correct Answer: D

Question 3

An Aruba controller can be configured to support which CLI based remote access methods?

A. SSH and RSH

B. SSH

C. Telnet and SSH

D. RSH

E. Telnet

Correct Answer: C

Question 4

What cannot be configured from the Initial Configuration wizards?

A. User derivation rules.

B. Syslog server and levels.

C. User firewall policy.

D. Controller name.

Correct Answer: B

Question 5

Which command, when executed on a master controller, will show the APs connected to an lms?

A. show stm connectivity

B. show ap database

C. show ap active

D. show ap bss-table

Correct Answer: B

Question 6

A 3200 controller has 16 PEF-NG license, 16 RFProtect license. There are 10 Campus Aps terminating on the controller, how many remote AP's can terminate on the controller?

A. 6

B. 16

C. 32

D. 24

Correct Answer: A

Question 7

Which of the following needs to be done prior to attempting to use the GUI quick setup of a factory defaulted Aruba S3500 Mobility Access Switch?

A. Set the laptop IP address to the 192.168.0.0 range

B. Quick-Setup needs to be enabled on the LCD Panel

C. Set the S3500 IP address to the 172.16.0.0 range

D. Connect the S3500 to the network for DHCP

Correct Answer: B

Question 8

An Aruba controller is configured with the correct IP address and gateway information and is connected to the corporate LAN via a core layer 2 switch. An access point is provisioned with AP name and group and connected to a different switch on the corporate LAN that has IP connectivity to the core layer 2 switch. The AP powers on and connects to the LAN, but the wireless radios do not power on.
Which could cause this condition? (Choose all of the correct answers.)

A. a DHCP server is not configured for the segment to which the AP is connected

B. the layer 2 switches have ACLs that block GRE traffic

C. the AP name needs to be configured on the Aruba controller

D. the layer 2 switches are configured to block multicast traffic

Correct Answer: A,B,D

Question 9

A campus AP has been provisioned with a VAP in bridge forwarding and standard operation modes. Which of the following authentication types are supported?

A. Open System authentication

B. Captive portal authentication

C. 802.1X authentication

D. Machine authentication

Correct Answer: A,C

Question 10

Which of the following configurations can accept a vlan pool?

A. User Role

B. Trunk native vlan

C. Virtual AP profile

D. Server derived role

Correct Answer: C

Question 11

Which of the following statement is true of the Spectrum Mode?

A. Spectrum mode can only be configured for one AP at a time

B. An AP can be in spectrum mode for both 2.4 and 5G bands at the same time

C. Spectrum Mode is configured under Spectrum Profile

D. No licenses are required to run an AP in Spectrum mode

Correct Answer: B

Question 12

What does Aruba's RF self-healing require to operate?

A. None of the above

B. LMS-IP

C. VRRP

D. Backup LMS-IP

Correct Answer: A

Question 13

What are aliases used for?

A. improve performance

B. assign rules to policies

C. simplify the configuration process

D. tie IP addresses to ports

Correct Answer: C

Question 14

Which of the following statements allows a user to initiate an HTTP session to other devices?

A. user any svc-http permit

B. any alias internal-nets svc-dns permit

C. any any svc-http permit

D. user user svc-http permit

Correct Answer: A,C

Question 15

When a port has been configured as untrusted, but no wired access AAA profile has been configured. A user connects to that port. What happens next?

A. When configuring the port as untrusted, an error message of "no wired access AAA profile exists". Therefore this is an invalid configuration.

B. Since there is no wired access AAA profile the user will be given the logon role

C. The user will fall into the default wired access AAA profile and will be given the initial role

D. Since there is no wired access AAA profile, only port policies will be applied

Correct Answer: B

Welcome to TestSimulate

Aruba Certified Mobility Professional 6.0 (ACMP) Free Practice Test