HP Aruba Certified Mobility Expert 6.4 Written (HPE6-A40) Free Practice Test
Question 1
Refer to the exhibits on the tabs.
Exhibit 1
Exhibit 2
A network engineer needs to deploy a Spectrum Analyzer (SA) and then monitor the 2.4Ghz and 5Ghz spectrum. As per the requirement, the engineer is able to convent some APs into SA temporarily, but when the engineer monitors the spectrum through the controller there are issues.
Based on the information shown in the exhibits, what is the issue?
Exhibit 1
Exhibit 2
A network engineer needs to deploy a Spectrum Analyzer (SA) and then monitor the 2.4Ghz and 5Ghz spectrum. As per the requirement, the engineer is able to convent some APs into SA temporarily, but when the engineer monitors the spectrum through the controller there are issues.
Based on the information shown in the exhibits, what is the issue?
Correct Answer: A
Question 2
A network engineer plans to deploy RAP. The company requires RAP to have redundancy so that it can failover to another controller if the primary controller fails.
Which RAP configuration should the engineer implement to meet these requirements?
Which RAP configuration should the engineer implement to meet these requirements?
Correct Answer: C
Question 3
Refer to the exhibit.
In Aruba architect plans to design a network for a school with a single controller. Wired clients and APs on each floor are mapped to different VLANs. The VLAN mapping is shown in the exhibit. Dot1x authentication is enabled for all the wireless clients, except guests, staff, and student users are mapped to VLAN 200 and 201, respectively. Controller up-link and all other inter switch links are trunk links and allow all necessary VLANs.
APs and wired clients are able to get the IP address and other necessary IP parameters. The core switch is doing the inter VLAN routing for the network.
Based on the setup shown in the exhibit, which IP configuration does the controller need? (Choose two.)
In Aruba architect plans to design a network for a school with a single controller. Wired clients and APs on each floor are mapped to different VLANs. The VLAN mapping is shown in the exhibit. Dot1x authentication is enabled for all the wireless clients, except guests, staff, and student users are mapped to VLAN 200 and 201, respectively. Controller up-link and all other inter switch links are trunk links and allow all necessary VLANs.
APs and wired clients are able to get the IP address and other necessary IP parameters. The core switch is doing the inter VLAN routing for the network.
Based on the setup shown in the exhibit, which IP configuration does the controller need? (Choose two.)
Correct Answer: B,E
Question 4
Refer to the exhibit.
A network engineer designs WLAN roaming for a company that has these requirements.
* Only employees are allowed to roam.
* Employees are allowed to roam from Campus 1 to HQ and from Campus 2 to HQ.
* Employees are not allowed to roam between Campus 1 and Campus 2.
What is the recommended roaming configuration to meet these requirements?
A network engineer designs WLAN roaming for a company that has these requirements.
* Only employees are allowed to roam.
* Employees are allowed to roam from Campus 1 to HQ and from Campus 2 to HQ.
* Employees are not allowed to roam between Campus 1 and Campus 2.
What is the recommended roaming configuration to meet these requirements?
Correct Answer: C
Question 5
There are three controller in a WLAN infrastructure: one Master and two locates, Local-1 and Local-2. By default, which database will be used for guest captive portal authentication when the internal user database is selected?
Correct Answer: C
Question 6
Which settings should be enabled on a firewall policy and applied to a role for voice devices to follow best practices? (Select two.)
Correct Answer: C,E