6002.1 Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation Exam (6002) Free Practice Test

Question 1

A user at a remote branch location is registered to a G450 media Gateway connected via processor Ethernet (PE) to a main communication manager in the core. The report that they are no longer able to place calls to users at the core
Which three procedures can be used to diagnose the source of problem? (Choose three)

A. Conform that the PE interface is active by executing the communication manager display processor Ethernet command and confirm that the allow H.248 Gateway field is set to Y.

B. Use the list survivable processor command to confirm that the survivable server is registered to the main communication manager.

C. Use the show MGC command on the media gateway to confirm the IP address of the
PE enabled server at the core is administered as the primary controller of the media gateway.

D. Confirm that the registered field on the communication Manager Display media-gateway to Y.

E. Use the list registered -IP-station command on the communication manager to determine whether the user on the media gateway is registered.

Correct Answer: B,D,E

Question 2

A customer has a communication Manager R6.0 system with IP phones and some older
TDM phone, and says there is no dial tone for all of the IP phones. All of the hardware has been verified to be working properly.
Which two steps can be taken to identify the cause of problem? (Choose two)]

A. Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.

B. Set a static IP address on a laptop and see if the server can be pined

C. Verify that the processor Ethernet mode is enabled in the Server.

D. Verify that the TN2602 Media resources circuit pack has the correct IP settings.

Correct Answer: A,D

Question 3

A technician is planning to support to upgrade an Avaya communication Manager system to release 6.0 from Release 5.2
Which two tasks must be performed during the upgrade procedure? (Choose two)

A. The survivable remote servers must be upgraded by Release 6.0

B. The survivable Remote servers can stay at Release 5.2

C. The S8700-series servers must be displayed by S8800 servers.

D. All G350 gateways must replaced by S8800 servers.

Correct Answer: A,C

Question 4

Which Ethernet port on S8800 server is for server duplication?

A. ETH0

B. ETH3

C. ETH1

D. ETH2

Correct Answer: B

Explanation: Only visible for TestSimulate members. You can sign-up / login (it's free).

Question 5

Which two hardware components support CM_survRemote template? (Choose two)

A. S8730 Servers with 8 GB RAM

B. S8300D Server

C. S8800 Servers

D. S8510 Server with 8 GB RAM

Correct Answer: C,D

Question 6

Which two statements regarding shuffling and hairpining are true? (Choose two)

A. Hairpining does not use media processor resources.

B. The audio connection type field on the communication manager status station formation can be used to determine whether a call is shuffled.

C. A call between a DCP endpoint and H.323 end point can be shuffled.

D. Shuffling release media processor resources.

Correct Answer: B,D

Question 7

When configuring a G450 Media gateway, which two port settings must be set? (Choose two)

A. 100 MB port speed

B. Auto-negotiation enabled

C. Full Duplex

D. FTP Server

Correct Answer: A,C

Welcome to TestSimulate

Avaya 6002.1 Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation (6002) Free Practice Test